1955-82 Spare Tire Hold Down Nut; 5/16"-18 Thread; 3.88" Wide; Zinc Finish
OER® reproduction wing nut for many GM models. This spare tire hold down nut is used in conjunction with the spare tire hold down rod. Manufactured in stamped steel and features correct threads and wing nut design....
1970-73 Camaro; Trunk Lock Bezel ; Chrome
Manufactured in quality zinc die-cast metal and chrome plated replicating the factory original bezel. Replace the old , worn out or rusted bezel with this quality reproduction. Will fit and install as original. Refer to part...
1959-72 Buick; Chevrolet; Oldsmobile; Pontiac; Trunk Lock Latch Assembly; Manual; Various GM Models
This OER® reproduction of the original manual trunk lid latch assembly. This correct reproduction installs in the trunk area and is connected to the trunk lock cylinder by the handle shaft. Allows the trunk lid to lock...
Reproduction OEM accessory rubber trunk mat with Buick shields logo for 1961-77 Buick models including Skylark, Electra and Riviera. This is an auxiliary mat that goes on top of the felt covering. This is an officially...
1968-69 Dodge B-Body Hardtop Trunk Lid Torque Rods
These reproduction trunk lid torque rods are manufactured from the correct gauge steel to factory specifications with the correct length and ends as original. Mopar Authentic Restoration™ Product Applications: 1968-69...
1969 Camaro; Trunk Lock Retainer
OER reproduction trunk lock retainer for 1969 Camaro models. Each retainer is manufactured in quality stamped steel to the original configuration replicating the original in design, appearance, and fitment. Features and...
1970-72 Oldsmobile 442, 1970-72 Cutlass, F85, Pontiac Tempest, Lemans, GTO; Hood Release Latch
Hood primary hood release latch for 1970-71 Oldsmobile 442 and 1970-72 Cutlass, F85, and 1970-72 Pontiac Tempest, Lemans, and GTO models. This latch is designed for applications that have an inside hood release cable. This...
1968-81 GM; Trunk Storage Sleeve, Wheel Jack and Wrench, 16-3/4" x 2-1/4"; Standard Size
Correct reproduction of the original storage sleeve for the trunk wheel jack and wrench unit. This special storage sleeve was found originally on many GM car models. Manufactured from quality rubber material, this sleeve...
1970-81 Camaro, Firebird; Trunk Hinge Torque Rod; with Rear Spoiler; RH Passenger Side
Reproduction of the original rear spoiler trunk hinge torque rod designed for use on 1970-81 Camaros with rear spoilers. This torque rod is essential for keeping pressure on the trunk hinge assembly which will maintain the...
1969 Dodge Charger; Inner Rear Trunk Tail Lamp Panel Cover
Reproduction rear trunk tail lamp cover for 1969 Dodge Charger models. Each panel is vacuum formed to correct factory specifications featuring the correct depth, configurations, and mounting points for an authentic...
1970 Dodge Charger; Inner Rear Trunk Tail Lamp Panel Cover
Reproduction rear trunk tail lamp cover for 1970 Dodge Charger models. Each panel is vacuum formed to correct factory specifications featuring the correct depth, configurations, and mounting points for an authentic...
1970-81 Camaro, Firebird; Trunk Hinge Torque Rod; with or w/o Rear Spoiler; LH Driver Side
Reproduction of the original rear spoiler trunk hinge torque rod designed for use on 1970-81 Camaros with rear spoilers. This torque rod is essential for keeping pressure on the trunk hinge assembly which will maintain the...
1965-74 Spare Tire Hold Down Rod Anchor Plate - Various GM Models
Be sure to protect your spare tire from unnecessary movement by making sure the spare tire anchor plate is correctly mounted. Acts as a clamp by holding the spare tire hold down rod in place after the nut is tightened....
1967-69 Camaro, Firebird; Trunk Lid Torque Rods; with Spoiler; RH & LH; Pair
Correct reproduction trunk lid torque tension rods for 1967-69 Camaro and Firebird models equipped with a rear spoiler. Each rod is manufactured to precise factory specifications and features the correct contours and...
1966 Olds 88, Dynamic, 1967-68 Camaro, Firebird, Trunk Lock Retainer Clip
Reproduction trunk lock retainer for 1966 Olds 88, Dynamic, and 1967-68 Camaro and Firebird models. Each retainer is manufactured from stamped steel and coated for rust prevention. Will replace the worn out or missing...
1970-81 Camaro; Firebird: Trunk Hinge Torque Rod; without Rear Spoiler; RH Passenger Side
Reproduction of the original rear spoiler trunk hinge torque rod designed for use on 1970-81 Camaros without rear spoilers. This torque rod is essential for keeping pressure on the trunk hinge assembly which allows the trunk...
1964-68 Oldsmobile Cutlass, 442; Bumper Jack; Hold Down; Bracket Kit
Reproduction bumper jack hold down bracket kit for 1964-68 Oldsmobile Cutlass and 442 models. This is the bracket that bolts to the trunk floor and secures the jack assembly in place. This is a rare part and can be hard to...
1968-81 GM; Trunk Storage Sleeve, Wheel Jack and Wrench, 16-3/4" x 2-3/4", Large
Correct OER reproduction storage sleeve for the wheel jack and wrench. Found on many GM car models. Manufactured from rubber, this sleeve slides over the jack in the trunk and then secures the wheel lug nut wrench. Measures...
1982-92 Camaro, Firebird; Rear Hatch Panel Trim Screw; Black; Each
Reproduction of the original interior trim fastener for the rear hatch cargo panel on 1982-92 Camaro and Firebird models. This trim screw is manufactured from correct injection molded ABS plastic material in the original...
1982-92 Camaro, Firebird; Rear Hatch Panel Trim Screw; Camel Tan
Reproduction of the original interior trim fastener for the rear hatch cargo panel on 1982-92 Camaro and Firebird models. This trim screw is manufactured from correct injection molded ABS plastic material in the original...
1982-92 Camaro, Firebird; Rear Hatch Panel Trim Screw; Red
Reproduction of the original interior trim fastener for the rear hatch cargo panel on 1982-92 Camaro and Firebird models. This trim screw is manufactured from correct injection molded ABS plastic material in the original...
1982-92 Camaro, Firebird; Rear Hatch Panel Trim Screw; Medium Blue; Each
Reproduction of the original interior trim fastener for the rear hatch cargo panel on 1982-92 Camaro and Firebird models. This trim screw is manufactured from correct injection molded ABS plastic material in the original...
1958-69 Trunk Spatter Paint; Black / Aqua; Aerosol Can; Net Weight 11 oz.; OER
After many years, your trunk area may need attention due to water damage or other factors. If you are replacing your trunk pan then spraying the trunk is a must, even if you're installing a trunk mat. OER's newly formulated...
1970-73 Camaro; Trunk Lock Bezel Gasket ; Molded Rubber
Correct OER® reproduction of the original trunk lock bezel molded rubber gasket for use with all 1970-73 Camaro models. This molded gasket is used to seal the trunk lock bezel and help keep water and other elements from...
Reproduction of the original type lock cylinder retainer required on various 1962-91 GM models. If you're replacing your lock cylinder, it will probably be necessary to replace the cylinder retainer. Manufactured in spring...
1969 Pontiac Firebird; Trunk Lock Bezel; with Hardware; GM Licensed
Add the finishing touch to your 1969 Firebird restoration with this quality reproduction trunk lock bezel. Features two studs and includes the 10-24 fastening nuts for mounting. Each die-cast bezel is polished to perfection,...
1982-92 Camaro, Firebird; Rear Window Hinge Bolt with Nut; Steel; Gloss Black; Each
Reproduction steel rear window hinge bolt and retaining nut for 1982-92 Camaro and Firebird models with rear lift-up window. The hex stud bolt is manufactured in steel with a plastic cap as original. Stud and nut are...
1969 Firebird, Trans Am; Trunk Lock Shaft And Swivel
Reproduction of the original trunk lock shaft and swivel unit designed for use specifically on 1969 Firebird and Trans Am models. This trunk lock shaft and swivel attaches to the trunk lock and features a swivel with a ball...
1981-87 Regal; Trunk Lock Cylinder Cover
Reproduction trunk lock cylinder cover for 1981-87 Regal models. Features adhesive backing for easy installation.
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
Trunk Spatter Paint Clear Topcoat; 16 Oz Aerosol Can; Net Wt. 16 Oz.
After years of use your trunk area is probably in poor condition due to water damage or other factors. If you are replacing your trunk pan then spraying the trunk is a must, even if you're installing a trunk mat. This is the...
1970-1982 GM: Trunk Spatter Paint; Black / Gray; Aerosol Can; Net Weight 11 oz.; OER
After many years, your trunk area may need attention due to water damage or other factors. If you are replacing your trunk pan then spraying the trunk is a must, even if you're installing a trunk mat. OER's newly formulated...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber; Various Models
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
1959-72 Buick, Chevy Pontiac, Oldsmobile; Trunk Latch Mounting Bolt Set; Various Models
Reproduction of the original 1/4-20 x 5/8 Hex Head SEMS machine screw style bolt with.750 toothed washer designed for mounting the trunk latch on various GM models. Manufactured to factory specifications featuring the correct...
1960-76 Dodge/Plymouth; Rubber Body and Trunk Plug; 1-7/8"; Each
Reproduction of the original style body and trunk rubber plug designed for use on most 1960-76 Dodge or Plymouth models where a 1-7/8" hole plug is required. Manufactured in quality rubber material for an original appearance,...
OER Black and Aqua Trunk Refinishing Kit with Standard Gray Primer
Restore the trunk area back to a factory original appearance with this OER® Trunk Refinishing Kit that contains practically everything you need to refinish the trunk of your classic vehicle. Kit Includes: 2 - 20 oz....
OER Black and Aqua Trunk Refinishing Kit with Self Etching Gray Primer
Restore the trunk area back to a factory original appearance with this OER® Trunk Refinishing Kit that contains practically everything you need to refinish the trunk of your classic vehicle. Kit Includes: 2 - 20 oz. Self...
OER Gray and White Trunk Refinishing Kit with Self Etching Gray Primer
Restore the trunk area back to a factory original appearance with this OER® Trunk Refinishing Kit that contains practically everything you need to refinish the trunk of your classic vehicle. Kit Includes: 2 - 20 oz. Self...
1971-90 Camaro, Firebird, Impala, Nova; Trunk Floor Pan Steel Access Plug; Various Models
Reproduction rear cross rail and trunk floor access plug originally installed on 1971-81 Camaro, Firebird, and other GM models as listed. Plugs are manufactured in steel to factory dimensions and will replace the original...
Trunk Spatter Paint; Gray / White; Aerosol Can; Net Weight 11 oz.; OER
After many years, your trunk area may need attention due to water damage or other factors. If you are replacing your trunk pan then spraying the trunk is a must, even if you're installing a trunk mat. OER's newly formulated...
OER Black and Gray Trunk Refinishing Kit with Standard Gray Primer
Restore the trunk area back to a factory original appearance with this OER® Trunk Refinishing Kit that contains practically everything you need to refinish the trunk of your classic vehicle. Kit Includes: 2 - 20 oz. High...
OER Gray and White Trunk Refinishing Kit with Standard Gray Primer
Restore the trunk area back to a factory original appearance with this OER® Trunk Refinishing Kit that contains practically everything you need to refinish the trunk of your classic vehicle. Kit Includes: 2 - 20 oz....
OER Black and Gray Trunk Refinishing Kit with Self Etching Gray Primer
Restore the trunk area back to a factory original appearance with this OER® Trunk Refinishing Kit that contains practically everything you need to refinish the trunk of your classic vehicle. Kit Includes: 2 - 20 oz. Self...
1982-92 Camaro, Firebird; Rear Hatch Panel Trim Screw; Medium Dark Gray
Reproduction of the original interior trim fastener for the rear hatch cargo panel on 1982-92 Camaro and Firebird models. This trim screw is manufactured from correct injection molded ABS plastic material in the original...