Universal Frame Mount Manual Brake Pedal Bracket Assembly; GM Booster Style; Under Floor Mount
Universal frame mount brake pedal assembly for GM style brake booster with 4 bolt 3-3/8? center. For automatic transmission equipped, left hand drive hot rod and truck models. Great for under the floor, frame mount...
1970-72 GM Clutch Fork Return Spring ; Various Models
OER® reproduction of the original clutch fork return spring which attaches from the clutch fork to the frame rail on models with manual transmissions. This reproduction spring replicates the original in every detail. Will...
1971-83 Chevrolet Camaro/Impala/Caprice/Pontiac Firebird; Clutch Pedal Push Rod Bushing
This small bushing is essential to keep the clutch push rod in the proper location. This OER® injection molded plastic bushing installs on the clutch pedal and retains the clutch push rod. This is a commonly worn out...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
Reproduction of the commonly worn out nylon pedal bushings designed for use with a variety of 1972-1991 GM car and truck models as listed. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...