1970 Chevrolet Camaro Parts - Accelerator Components

This special mounting pin is just what you need to correct a loose accelerator pad. This special design allows the pad to attach to the accelerator arm correctly and tightly. Replacing this pin will fix the problems commonly...

This is an OER® reproduction of the original type tension spring that will enable your gas pedal pad to position itself properly. This spring attaches under the pedal pad and attaches to the rod assembly to keep the pedal...

OER® reproduction of the correct cable retainer used to hold the accelerator control cable. This retainer slips over the cable and clips into the hole on the accelerator pedal arm. Manufactured in injection molded plastic...

Reproduction of the original accelerator throttle cable bracket for use on 1970-72 Camaro and Firebird models with Holley Carburetors. This quality bracket is manufactured in stamped steel to the original factory...

1976-1976 Chevrolet Pickup Truck (C/K Series) (1st Design) 1971-1972 Chevrolet Blazer 1976-1976 Chevrolet Blazer (1st Design) 1979-1984 Chevrolet G10, G20, G30 Series Van 1979-1984 Chevrolet P10, P20, P30 Series Van ...

Reproduction of the original accelerator pedal trim plate designed for use on various GM models. Manufactured to exact factory dimensions, each trim plate is stamped in quality stainless steel offering a supurb appearance....

Correct OER® reproduction of the original floor mounted accelerator pedal pad installed on various GM models. Each accelerator pedal pad is manufactured in quality hard EPDM rubber unlike the plastic service replacement...

Correct reproduction accelerator pedal pad stainless trim plate for various 1965-71 GM vehicles. Each trim plate is manufactured in stamped stainless offering long lasting dependability and an authentic appearance. This...

This complete kit is designed to replace pedal pads and trim plates on 1970-71 models with floor mounted gas pedal , drum brakes and a manual transmission. For models with the 3" clutch pedal. To ensure proper fit, measure...

Reproduction of the original pedal pads and trim plates for use on 1970-71 Camaro Z/28 models. This complete kit is designed to replace pedal pads and trim plates on 1970-71 Z/28 models with drum brakes and automatic...

This complete kit is designed to replace pedal pads and trim plates on 1970-71 models with floor mounted gas pedal , drum brakes and a manual transmission. For models with the 3" clutch pedal. To ensure proper fit, measure...

This complete kit is designed to replace pedal pads and trim plates on 1970-71 Z28 models with disc brakes and an automatic transmission. Kit includes Accelerator pedal pad Disc Brake pedal pad with the "Disc Brakes" chrome...

Reproduction of the original pedal pads designed for 1969-71 Camaro and 1970-71 Firebird models equipped with 3" brake and clutch pedal. Each pad is manufactured to original factory specs! 8 piece set includes the 3" brake...

Reproduction of the original pedal pads and pedal pad trim plates to fit various GM models. This pedal pad set is designed to replace the worn out original pads for models equipped with automatic transmission. Replacing the...

Reproduction of the original pedal pads and pedal pad trim plates to fit various GM models. This pedal pad set is designed to replace the worn out original pads for models equipped with disc brakes and automatic transmission....

OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...

Universal style accelerator throttle rod designed for use on various GM, Ford, Chrysler, Dodge, Plymouth models. This accelerator rod is for use when modifications will not allow the use of the original rod between the...