1964-67 Chevelle, El Camino, Clutch Bell Crank; Cross Shaft, Z-Bar; Big Block Engines
Reproduction of the original clutch bell crank for use with 1964-67 Chevelle & El Camino with big block engines. What the cross shaft, clutch push rod and pedal assembly attaches to. The pivot point that allows the clutch...
1968-72 Various GM Vehicles Including Chevelle, LeMans, Cutlass; Upper Clutch Rod; Pedal To Z Bar
Reproduction of the correct clutch rod for 1968-72 Pontiac GTO Upper clutch rod pedal to Z Bar they are 100% correct. These are hardened steel with correct offset. These rods go from the Z bar to the clutch pedal. They...
1958-83 GM; Clutch Bellcrank Pivot Ball; Block Side; Screw-In Type; 3" Overall Length
This is an exact reproduction of the original block side pivot ball screw designed for use with various 1958-83 GM models as listed. Each clutch bellcrank pivot ball is manufactured from hardened steel replicating the...
A reproduction installation set for use when installing a Hurst Competition Plus shifter on 1968 and earlier Muncie 451 transmission. See various applications listed. Can also be used for custom installs on various passenger...
Shifter Install Kit; For Hurst Shifter and Muncie 452/453 Transmissions
Reproduction shifter installation kit required to fit a Competition Plus Shifter on various GM models including 1969-70 Chevy Nova models equipped with Muncie 452 or 453 transmissions. It will work with or without the factory...
1964-67 Chevelle, El Camino, Clutch Bell Crank; Cross Shaft, Z-Bar; Small Block; 283ci, 327ci
Reproduction of the original cross shaft Z bar for use with 1964-67 Chevelle and El Camino models. What the cross shaft, clutch push rod and pedal assembly attaches to. The pivot point that allows the clutch pedal to depress...
1970-79 Various GM Applications; Manual Transmission; Hurst Shifter; Lower Dust Shield
Replacement Hurst shifter stainless steel lower dust shield for various 1964-81 GM applications including El Camino, Grand Prix, Firebird models. For applications with Hurst shifter. This mounts on the bottom of the shifter...
Swivel assembly for manual transmission shift control linkage, automatic transmission column shift linkage or reverse lockout on a wide variety of GM models from 1938-91. This set includes many of the necessary pieces to...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...