1964-67 Chevelle, El Camino, Clutch Bell Crank; Cross Shaft, Z-Bar; Big Block Engines
Reproduction of the original clutch bell crank for use with 1964-67 Chevelle & El Camino with big block engines. What the cross shaft, clutch push rod and pedal assembly attaches to. The pivot point that allows the clutch...
1968-72 Various GM Vehicles Including Chevelle, LeMans, Cutlass; Upper Clutch Rod; Pedal To Z Bar
Reproduction of the correct clutch rod for 1968-72 Pontiac GTO Upper clutch rod pedal to Z Bar they are 100% correct. These are hardened steel with correct offset. These rods go from the Z bar to the clutch pedal. They...
1958-83 GM; Clutch Bellcrank Pivot Ball; Block Side; Screw-In Type; 3" Overall Length
This is an exact reproduction of the original block side pivot ball screw designed for use with various 1958-83 GM models as listed. Each clutch bellcrank pivot ball is manufactured from hardened steel replicating the...
Shifter Install Kit; For Hurst Shifter and Muncie 452/453 Transmissions
Reproduction shifter installation kit required to fit a Competition Plus Shifter on various GM models including 1969-70 Chevy Nova models equipped with Muncie 452 or 453 transmissions. It will work with or without the factory...
A reproduction installation set for use when installing a Hurst Competition Plus shifter on 1968 and earlier Muncie 451 transmission. See various applications listed. Can also be used for custom installs on various passenger...
1964-67 Chevelle, El Camino, Clutch Bell Crank; Cross Shaft, Z-Bar; Small Block; 283ci, 327ci
Reproduction of the original cross shaft Z bar for use with 1964-67 Chevelle and El Camino models. What the cross shaft, clutch push rod and pedal assembly attaches to. The pivot point that allows the clutch pedal to depress...
1970-79 Various GM Applications; Manual Transmission; Hurst Shifter; Lower Dust Shield
Replacement Hurst shifter stainless steel lower dust shield for various 1964-81 GM applications including El Camino, Grand Prix, Firebird models. For applications with Hurst shifter. This mounts on the bottom of the shifter...
Reproduction Steering Lock Out Swivel Insulator Bushing for 1969-72 GM A-Body, F-Body, and X-Body vehicles. Keep your steering lock-out system tight and rattle-free. Don't let a worn or missing insulator ruin the precise feel...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...