1962-67 Chevy II, Nova; Mono Rear Leaf Springs; Pair; Made in the USA
These reproduction rear leaf springs are designed for an exact, direct replacement of the originals. Reproduction of the original mono rear leaf springs designed for use with 1962-67 Chevy II and Nova models. Each leaf spring...
1967-69 Camaro, Firebird; Mono Rear Leaf Springs; Convertible; Pair; Made in the USA!
Reproduction of the original mono rear leaf springs designed for use with 1967-69 Camaro, Firebird models models. Each leaf spring is manufactured to factory specifications and replicates the original in quality, design, and...
1967-69 Camaro, Firebird, 1968-79 Nova; Mono Rear Leaf Springs; Pair; Made in the USA!
Reproduction of the original mono rear leaf springs designed for use with 1967-69 Camaro, Firebird models, and 1968-79 Chevy II, Nova, and X-body models. Each leaf spring is manufactured to factory specifications and...
5 Leaf Rear Leaf Springs (Spring Rate 143 Lbs) - Replacement Style
Replace the sagging leaf springs on your classic GM vehicle with this quality set produced by OER! These replacement rear leaf springs are designed to replace the original multi-leaf spring set while featuring a precise...
3-1/4" Wide X 6-3/4" Long Leaf Spring U-Bolts
Reproduction OE-style U-bolts and nuts for rear leaf springs from OER®. 2 pair required per axle. Comes with heat treated grade 8 nuts and F436 heat treated and hardened heavey duty washers. {specs} Applications: ...
1970-81 Rear Spring Shackle Bushing ; Camaro, Firebird, Nova, X-Body
Replace your cracked or worn out original rear spring shackle bushings and bring your rear suspension back to original factory ride specifications. Each bushing is designed and manufactured to replicate the original in...
1968-69 Camaro / Firebird Mono To Multi Leaf Conversion Hardware Kit with 3-1/2"" U Bolts
Converting your original mono rear leaf springs to multi leaf is no sweat with the OER® conversion kit. Many models came equipped with mono leaf springs, but changing over to a multi leaf setup will allow better rear axle...
1968-69 Camaro / Firebird Mono To Multi Leaf Conversion Hardware Kit with 3" U Bolts & T Bolts
Converting your original mono rear leaf springs to multi leaf is no sweat with the OER® conversion kit. Many models came equipped with mono leaf springs, but changing over to a multi leaf setup will allow better rear axle...
1970-81 Camaro, Firebird, 1962-79 Chevy II, Nova and X-Body; Rear Spring Shackle Bushing Set
Reproduction of the original rear spring shackle kit designed for use on various GM models. Each shackle kit replaces the old or worn out original hardware and bushings with this quality reproduction. Includes all of the...
Coil Spring Spacer; 9/16" Thick; EPDM Rubber; Each
Reproduction of the original 9/16" coil spring spacer designed for various GM models. This spacer is manufactured from durable EPDM rubber. This spacer was used to correct the ride height on vehicles that did not sit level...
1953-62 Chevy Corvette; Leaf Spring Shackle Kit; LH or RH; Per Side
Reproduction if the original style rear leaf spring shackle components designed to replace the ols or worn out originals for 1953-62 Chevrolet Corvette models. Each shackle kit includes 8 total pieces to fit either the LH or...
1956-57 Chevy Bel Air, 150, 210; Leaf Spring Shackle Set; LH Driver Side
Reproduction rear leaf spring shackle for 1956-57 Chevrolet Bel Air, 150, 210 models. This shackle set is manufactured to correct factory specifications offering an authentic replacement to the old or worn out original...
1970-81 Camaro / Firebird Rear Leaf Spring Pad Set
Each pad is used to insulate the area between the spring and the mounting plate. Two upper pads and two lower pads are required on vehicles with leaf springs.
1968-69 Camaro / Firebird, 1968-79 Nova Multi Leaf Spring Pad Set
Each pad is used to insulate the area between the spring and the mounting plate. Two upper pads and two lower pads are required on vehicles with leaf springs. Note: When converting 1967-69 single to multi leaf a...
1964-66 Various GM Applications; Rear Coil Spring; Hold Down Clamps
This is the rear coil spring hold down clamp for rear end. New reproduction this factory mounting clamp that holds the rear coil spring to the rear end. Without these clamps, your spring will make a "clunking" noise when...
1960-72 Chevrolet, GMC Truck; Single Coil Spring Retainer; Upper and Lower; Each
Reproduction of the original single coil spring retainer for use with 1960-72 Chevrolet and GMC model trucks. Each retainer cup is manufactured in stamped steel to original factory specifications featuring correct contours...
1964-1981 Various GM Vehicles; Coil Spring; Spacer 3/8"
We now have reproduction of the coil spring spacer that goes between the front lower control arm and spring for 1964-81 GM Applications including Camaro, Firebird Cutlass and GTO models. It is perfect to lift the front end a...
1967-81 Rear Spring Eye Bracket Bolt Set (6 piece)
Quality reproduction of the original rear spring eye bracket bolt designed to mount the leaf spring front eye bracket. Each bolt is case hardened for durability and long lasting performance. 6 bolts included in each set. ...
1963-82 Corvette; Rear Leaf Spring Rubber Cushion
Replacement rear leaf spring rubber cushion for 1963-82 Corvette models. Sold individually. Four required per vehicle.
1967-69 Camaro Z/28, Firebird 400, Nova; Rear Leaf Springs; 4 Leaf; Spring Rate 126 lbs; Pair
Reproduction of the original 4 leaf rear leaf springs designed for use with 1967-69 Camaro Z28 (302), 1968-81 Firebird 400 and performance models, Chevy II Nova and GM X-body models with 4 leaf rear springs. Each leaf spring...