Universal Frame Mount Manual Brake Pedal Bracket Assembly; GM Booster Style; Under Floor Mount
Universal frame mount brake pedal assembly for GM style brake booster with 4 bolt 3-3/8? center. For automatic transmission equipped, left hand drive hot rod and truck models. Great for under the floor, frame mount...
1967-81 Camaro, Impala, Nova; Clutch Fork; 6 or 8 Cyl.; Heavy Duty Replacement;
Reproduction of the original style clutch fork designed for use on various 1967-81 Camaro, Impala, Caprice, Bel Air, Biscayne, and Chevy II Nova models with manual transmissions as listed below. This quality reproduction of...
1971-83 Chevrolet Camaro/Impala/Caprice/Pontiac Firebird; Clutch Pedal Push Rod Bushing
This small bushing is essential to keep the clutch push rod in the proper location. This OER® injection molded plastic bushing installs on the clutch pedal and retains the clutch push rod. This is a commonly worn out...
Lower Clutch Push Rod ; Various GM Models
OER® reproduction of the original lower clutch push rod adjustor designed for use on various GM models. This push rod is manufactured to original specifications and includes the swivel. Will replace any original non...
1958-79 Chevrolet; Flywheel Clutch Housing Cover; for 10-1/2" Bellhousing; Manual Trans; OER
Correct flywheel / clutch cover plate designed for use with the various 1958-79 Chevrolet models as listed. Each cover is manufactured in quality stamped steel for an authentic replacement. This cover is located on the back...
1965-83 Buick, Chevy, Pontiac, Olds; Clutch Fork Ball Stud; Each
Replacement clutch fork ball stud for various 1965-83 Buick, Chevrolet, Pontiac, and Oldsmobile models. This stud attaches inside the clutch bellhousing to provide a pivot point for the clutch fork. Measures 13/16" -16 x...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
Reproduction of the commonly worn out nylon pedal bushings designed for use with a variety of 1972-1991 GM car and truck models as listed. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...