1970-73 Camaro, Firebird; Complete Trunk Floor; with Frame Rails; EDP Coated
Reproduction of the complete trunk floor and rear frame rails section designed for use with 1970-73 Camaro and Firebird models. Each trunk floor and frame rail section is manufactured in stamped steel to original factory...
1970-73 Camaro; Trunk Drop Off Lower Side Panel; RH
Reproduction of the original inner lower trunk drop off extension for use with 1970-73 Camaro models. Manufactured in quality stamped steel to correct dimensions including the trunk plug drain hole. This panel is located...
1970-73 Camaro; Trunk Drop Off Lower Side Panel; LH
Reproduction of the original inner lower trunk drop off extension for use with 1970-73 Camaro models. Manufactured in quality stamped steel to correct dimensions including the trunk plug drain hole. This panel is located...
1970-73 Camaro, Firebird; Complete Trunk Floor with Frame Rails; Silver Weld-Thru Primer
Reproduction of the complete trunk floor and rear frame rails section designed for use with 1970-73 Camaro and Firebird models. Each trunk floor and frame rail section is manufactured in stamped steel to original factory...
1970-73 Camaro, Firebird; Full Trunk Floor Pan; EDP Coated
Reproduction of the original trunk floor pan designed for use with 1970-73 Camaro, Firebird, and Trans Am models. Each trunk floor panel is manufactured in stamped steel to original factory specifications featuring correct...
1970-73 Camaro, Firebird; Trunk Pan; Stamped Steel; EDP Coated
Reproduction of the original center trunk pan designed for use with 1970-73 Camaro and Firebird models. Each trunk pan is manufactured to factory dimensions in quality stamped steel replicating the original in appearance and...
1970-73 Camaro, Firebird; Rear Seat Back Panel; Stamped Steel; EDP Coated
Reproduction of the original rear seat back panel for use with 1970-73 Camaro and Firebird models. Each rear seat back panel is manufactured in stamped steel to original factory specifications featuring correct contours for...
1970-73 Camaro, Firebird; Fuel Tank Brace Set; 4 Piece Set; EDP Coated
Reproduction of the original fuel tank brace set designed for use with 1970-73 Camaro and Firebird models. Each fuel tank brace is manufactured in stamped steel to original factory specifications featuring correct contours...
1970-73 Camaro / Firebird; Tail Panel Brace ; with EDP Coating
Reproduction of the original tail panel brace designed for use on 1970-73 Camaro and Firebird models. The tail panel brace is a must for any trunk area restoration. Mounts between the trunk floor and tail panel. This quality...
1962-96 Rubber Plug; 11/16" I.D. Hole ; Various GM Models
Reproduction of the original type rubber plug that's designed for use on various locations in the vehicle. This plug is designed to keep air and water from entering specific areas that could cause problems, including the...
1971-81; Trunk Floor Pan Access Plug
Reproduction of the original trunk floor drain plug originally installed on 1971-81 Camaro and Firebird models.Plugs are manufactured to factory dimensions and will replace the original damaged, rusted or worn out plug...
1962-81 GM; Floor Pan and Trunk Pan Plug; Oval; Stamped Steel Reproduction
Reproduction of the original oval metal floor pan and trunk pan plug used by General Motors on various 1964-81 models. Located on both the front and rear floor pans and the trunk floor pan, this plug is manufactured using...