Reproduction of the original hydraulic hose set designed for use with a wide variety of convertible models as listed. Finding an original hose for your early convertible is next to impossible. If you own a convertible model...
This OE style replacement motor and pump assembly features original style locations for electric and fluid connections. Fits a wide variety of 1964-93 Ford, Mercury, Chrysler, Dodge, Plymouth models including, but not limited...
1970-71 Challanger, Barracuda, Cuda; Convertible Top Hydraulic Cylinder; Each; Made in the USA!
Reproduction of the original convertible top cylinder designed for use with 1970-71 Dodge Challenger, Plymouth Barracuda, and Cuda convertible models. All convertible top cylinders are not the same. This convertible top...
1971 Challenger, Barracuda, Cuda; Convertible Anti Rattle Clips; Pair
Reproduction of the original convertible anti-rattle clips for use with 1971 Challenger, Barracuda, and Cuda models. These go on top of the windshield where the locating pins go in. These special clips were designed to keep...
1949-75 GM, Dodge, Plymouth; Convertible Top Rear Window Binding End Clip, with Screw
OER reproduction of the original convertible top rear binding end clip that was used for most 1949-75 GM, Dodge, and Plymouth convertible models. This stainless steel end clip covers covers and finishes both ends of the rear...
1951-75 Convertible Power Top Motor Mounting Grommet - Each
Reproduction of the original rubber mounting / insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a...