Product#: 3415

Bumper Bolt with Conical Keps Hex Nut; Polished Stainless Steel Capped Head; 3/4" Diameter; 3/8-16" x 1"; Zinc Plated

Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...


Product#: 2710

Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head

Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...


Product#: 8610

Flat Washer; 1/2" USS; Zinc Plated

1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...


Product#: 13757

1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon

Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...


Product#: 10362

Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate

OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...


Product#: 3899508

1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each

Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...


Product#: K51020

1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Storage Bag

Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot storage bag. The storage bag will help protect your vehicles top boot while being stored in the...


Product#: 153391

1966-84 Wiper Blade; 16" Anco Style; 1/4" Bayonet Connector; Polished Stainless; Each

Reproduction 16" wiper blade assembly manufactured to factory specifications, featuring a bright polished stainless steel finish and premium wiper insert. Fits 1/4" bayonet end wiper arms. Sold individually. Product...


Product#: 11503957

U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...


Product#: A1017

3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each

Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...


1970-71 Ford Torino, Mercury Montego; Convertible Top Rear Tack Strip Bow Set; Tacking Rail; Trimstick; 3-Piece
NEW

Product#: FTS7071

1970-71 Ford Torino, Mercury Montego; Convertible Top Rear Tack Strip Bow Set; Tacking Rail; Trimstick; 3-Piece

Replace the worn or rusted out rear convertible tack strip bow or rear tacking rail set with this quality reproduction. This 3 piece tack strip, also referred to as a trimstick set mounts below the rear window area inside the...


Product#: ME7602

Wiper Blade Insert; Replacement; 16" Anco Style; Each

OER reproduction Anco-style windshield wiper blade insert for various classic American vehicle models from the 1960's and up. These 16" wiper blades are manufactured from quality molded rubber as original. Refill is...


Product#: 17528D

16" Windshield Wiper Blade Refill; Pair; 16" x 3/8" wide

Reproduction of the windshield wiper blade inserts for various models equipped with 16" wiper blades. Each blade insert is manufactured for perfect fit, function and appearance when used with the proper blade assembly....


Product#: 22810H

1971-73 Mustang/ Mercury Cougar; Lower Door Hinge; Drivers Side; LH

Reproduction of the lower door hinge designed to replace the worn out or damaged original on 1970-71 Ford Fairlane/Torino/Ranchero and 1971-73 Mustang and Cougar models. After years of continuous use, your doors can begin to...


Product#: 22810G

1971-73 Mustang/Mercury Cougar; Lower Door Hinge; Passenger Side; RH

Reproduction of the lower door hinge designed to replace the worn out or damaged original on 1970-71 Ford Fairlane/Torino/Ranchero and 1971-73 Mustang and Cougar models. After years of continuous use, your doors can begin to...


Product#: 11500367

1965-2002 GM; Door Lock Striker Washer; 3.50MM Thick; Each

Correct reproduction of the original threaded striker washer for use on 1965-2002 Buick, Chevrolet, Pontiac, and Oldsmobile models as listed. The door lock striker washer is installed on the door jamb for either the right or...


Product#: 17529B

1960-84 Windshield Wiper Blade; 16" Trico; Rainbow Type; 1/4" Bayonet Connector; Matt Stainless

Reproduction of the original Trico Rainbow Type wiper blade designed for various models originally equipped with Trico blades. Each wiper blade will replace the original and offer years of service. Each blade comes complete...


Product#: 153078

1967-69 Camaro, Firebird; Convertible Top Boot Interior Snaps with Screws; 4 Piece Set

Reproduction convertible top boot snap and screw set for 1967-69 Camaro and Firebird models and any other vehicle that requires a screw-on style snap. These snaps are used to secure the convertible top to the inner rear...


Product#: 10182

Tapping Screw; #8 x 1"; Phillips Pan Head; A/AB; Black Oxide

This reproduction screw can be used on many applications where a #8 X 1" phillips pan head Zinc plated tapping screw is needed. Sold individually.


Product#: 4469196

Door Lock Striker Bolt Washer Shim ; 1.25MM Thick ; Each

Reproduction of the original door striker bolt shim manufactured in die-stamped steel and finished in clear zinc coating. Used to correctly position the door striker bolt for proper alignment with the door latch assembly. Use...