Throttle Cable 36"" Cut-To-Fit; Stainless Steel; Black
This throttle cable is designed with a specially extruded liner to extend the life of the cable. Cables are equipped with aluminum fittings and aluminum ferrule to eliminate fraying. Clevis is designed to eliminate cotter...
1946-02 GM; Various Models; Throttle Cable; 36""; Stainless Steel ; Cut-To-Fit
This throttle cable is designed with a specially extruded liner to extend the life of the cable. Cables are equipped with aluminum fittings and aluminum ferrule to eliminate fraying. Clevis is designed to eliminate cotter...
Spring Steel Rod Clip, Fits 1/4" Rod Diameter, RH, 17/64" ID.
Correct style rod clip used on various GM vehicles. Fits 1/4" rod diameter, RH, 17/64" ID. These reproduction transmission linkage rod clips need to be replaced when replacing your linkage rods. 1955-57 Chevrolet...
1958-88 Holley Carburetor Fuel Bowl Screw; 2-1/2"
Reproduction 2-1/2" flat blade carburetor fuel bowl screw for Holley carburetors. This special screw is specifically designed in the correct original configuration and head design for the early model Holley carburetors. Many...
Holley Carburetor Float Bowl Screws; Set of 8
Reproduction set of 2-1/2" flat blade carburetor fuel bowl screws for Holley carburetors. These special screws are specifically designed in the correct original configuration with the proper head design for the early model...
1955-79 Air Cleaner to Carb Gasket; 5-1/8" .060" Thick; Various Models; Universal Fit
Reproduction air cleaner to carburetor gasket manufactured for use with any 2 bbl or 4 bbl carburator with a 5-1/8" base. Can be used with any small or big block engine. Fits most 1964 and newer Ford applications, most 1965...
1967-77 Pontiac Firebird, 1967-73 GTO; Dust Boot; Accelerator Pump; Quadrajet Ram Air
Reproduction of the accelerator pump dust boot for 1967-77 Firebird and 1967-73 GTO with a Quadrajet Ram Air setup. The accelerator mounts inside the carburator and is operated by a lever. This boot keeps dust and other...
1968-74 Firebird, Trans Am; Aluminum Rear Carburetor Fitting; with Angled Fitting
Reproduction of the original carburetor rear fitting designed specifically for use with 1968-74 Pontiac Firebird and Trans Am models with 326, 350, 400, and 455 motors with or without Ram Air. This fitting screws to the back...
1968-75 Firebird, Trans Am; Carburetor Rear Fitting; with Straight Fitting
Reproduction of the original aluminum carburetor fitting designed for use with 1968-75 Pontiac models including Firebird and Trans Am. This particular fitting was used on most all 1968-69 Firebird models, but can also be used...
1962-1982 GM; Carburetor, Door, Tailgate; Spring Steel Rod Clip; RH Passenger Side
OER® Authorized reproduction of the original style carburetor rod to accelerator rod clip for various models. Each clip is manufactured in stamped steel and heat treated for strength and durability. For use on the various...