This is The plastic clutch bell crank or Z bar insert set that allow the bar to pivot. These are present on most all GM cars from 1958-88 with a manual transmission. This four piece set which includes 3 nylon bushings and a...
1967-70 Camaro Shift Plate Retainer ; w/o Console ; Manual Transmission
Reproduction of the original GM shift boot and plate retainer for use on all 1967-70 Chevrolet Camaro models 4 speed manual transmissions without a floor console. This retainer is manufactured in stamped steel and used to...
1969 Camaro Hurst Shifter Lever Hardware
Reproduction of the original 1969 Camaro Hurst shift lever hardware designed to replace broken, damaged or worn out originals. Includes high strength steel bolts and washers as shown.
1953-2010 GM; Rear Axle/Transmission Ventilator; for 3/8" Hole
OER® reproduction of the ventilator used by GM on a multitude of applications from the 1950s thru todays cars and trucks including the rear axle housing, automatic transmissions. front transfer case on 4 x 4 models and...
1963-74 Chevrolet; Retainer Clip; For Transmission Back-Up Switch Wire; Cushioned, Insulated
Replacement back-up lamp switch wire harness retaining clip for models with a muncie transmission. This clip mounts the reverse back-up lamp switch wire harness to the bellhousing. This is an exact reproduction of the...