1965-68 Various GM 2DR Hardtop & Convertible; Door Vent Window; Weatherstrip Set
NEW

Product#: WS4719P

1965-68 Various GM 2DR Hardtop & Convertible; Door Vent Window; Weatherstrip Set

Reproduction of the original front door vent window weatherstrip for use with various 1965-68 GM 2 door hardtop and convertible models. This is a four (4) piece set that contains the main vent window seals and division post...


Product#: 3853970

1964-72 Buick, Chevrolet, Oldsmobile, Pontiac; Fuel Tank Vent Tube Grommet; Each

Replacement vent tube grommet for 1964-72 GM models. Manufactured to factory dimensions, this molded rubber grommet fits in the trunk pan and features two holes for the fuel vent tube to pass through.


Product#: 1667195

1955-1976 GM; Rubber Floor Pan Plug; Each

Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...


Product#: 5960074

1968 Firebird Rear Side Marker Gaskets; Black; Pair

Reproduction rear side marker gaskets for 1968 Firebird and Pontiac full size passenger car models (except wagon). Each gasket is die-stamped in OE type gasket material featuring same thickness as original. Manufactured in...


Product#: W2347

1967-68 Impala, Wildcat, Delta 88; Roof Rail Weatherstrip Seal, 2-Door Fastback; Pair

Reproduction of the original roof rail weatherstrip designed for use on 1967-68 Impala 2 door Fastback, Wildcat, Le Sabre, and various GM models as listed below. This quality reproduction weatherstripping is manufactured in...


Product#: K456

1967-68 Impala, GM, Roof Rail Weatherstrip, 2 Door, Hardtop, Pair

Correct reproduction of the original roof rail weatherstrips designed for use on 1967-68 Impala and Full Size GM 2 door hardtop models. Eliminate water or other elements from entering the passenger area by replacing these...


Product#: 340999

1954-1981 Hood Adjustor Bumper and Stud - Various GM vehicles

Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...