1967 F-Body Frame Side Clutch Pivot Ball Bracket
OER® Reproduction of the frame side clutch pivot ball bracket. Features the correct offset and holes as original and is used for L6, small block and big block models. Applications 1967 Camaro 1967 Firebird You...
This is The plastic clutch bell crank or Z bar insert set that allow the bar to pivot. These are present on most all GM cars from 1958-88 with a manual transmission. This four piece set which includes 3 nylon bushings and a...
1953-2010 GM; Rear Axle/Transmission Ventilator; for 3/8" Hole
OER® reproduction of the ventilator used by GM on a multitude of applications from the 1950s thru todays cars and trucks including the rear axle housing, automatic transmissions. front transfer case on 4 x 4 models and...
1963-74 Chevrolet; Retainer Clip; For Transmission Back-Up Switch Wire; Cushioned, Insulated
Replacement back-up lamp switch wire harness retaining clip for models with a muncie transmission. This clip mounts the reverse back-up lamp switch wire harness to the bellhousing. This is an exact reproduction of the...