Universal Frame Mount Manual Brake Pedal Bracket Assembly; GM Booster Style; Under Floor Mount
Universal frame mount brake pedal assembly for GM style brake booster with 4 bolt 3-3/8? center. For automatic transmission equipped, left hand drive hot rod and truck models. Great for under the floor, frame mount...
1962-67 Chevy II / Nova Clutch Bellcrank; 10-3/4" length
Precision reproduction of the original clutch bellcrank unit designed for use on 1962-67 6- cylinder and small block Chevy II and Nova models. This bellcrank is manufactured in stamped steel and replicates the original in...
1958-79 Chevrolet; Flywheel Clutch Housing Cover; for 10-1/2" Bellhousing; Manual Trans; OER
Correct flywheel / clutch cover plate designed for use with the various 1958-79 Chevrolet models as listed. Each cover is manufactured in quality stamped steel for an authentic replacement. This cover is located on the back...
1965-83 Buick, Chevy, Pontiac, Olds; Clutch Fork Ball Stud; Each
Replacement clutch fork ball stud for various 1965-83 Buick, Chevrolet, Pontiac, and Oldsmobile models. This stud attaches inside the clutch bellhousing to provide a pivot point for the clutch fork. Measures 13/16" -16 x...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
1967-72 Small Block Clutch Fork Return Spring
OER® reproduction clutch fork return spring. Attaches from the engine mounting bracket to the clutch extension wire. Measures 3-5/8" O.L. 2-1/2" spring portion. Applacations: 1967-69 Camaro small block 1967-69...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1962-67 Brake and Clutch Pedal Pad ; without Power Brakes
Reproduction of the original brake and clutch pad designed for use on various GM models with a manual transmission and standard brakes. Each pad is manufactured in quality RPDM rubber replicating the original in quality and...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...