This is The plastic clutch bell crank or Z bar insert set that allow the bar to pivot. These are present on most all GM cars from 1958-88 with a manual transmission. This four piece set which includes 3 nylon bushings and a...
1967 F-Body Frame Side Clutch Pivot Ball Bracket
OER® Reproduction of the frame side clutch pivot ball bracket. Features the correct offset and holes as original and is used for L6, small block and big block models. Applications 1967 Camaro 1967 Firebird You are assured...
1967-68 Camaro; Shifter Stabilizer Bar
OER® Authorized reproduction of the shifter stabilizer rod also known as the front strut rod transmission mounting bracket for 1967-68 Camaro models. This stabilizer rod goes from the shifter assembly to the transmission...
1967-70 Camaro Shift Plate Retainer ; w/o Console ; Manual Transmission
Reproduction of the original GM shift boot and plate retainer for use on all 1967-70 Chevrolet Camaro models 4 speed manual transmissions without a floor console. This retainer is manufactured in stamped steel and used to...
1953-2010 GM; Rear Axle/Transmission Ventilator; for 3/8" Hole
OER® reproduction of the ventilator used by GM on a multitude of applications from the 1950s thru todays cars and trucks including the rear axle housing, automatic transmissions. front transfer case on 4 x 4 models and...
1963-74 Chevrolet; Retainer Clip; for Transmission Back-Up Switch Wire; Cushioned, Insulated
Replacement back-up lamp switch wire harness retaining clip for models with a muncie transmission. This clip mounts the reverse back-up lamp switch wire harness to the bellhousing. This is an exact reproduction of the...