Universal Frame Mount Manual Brake Pedal Bracket Assembly; GM Booster Style; Under Floor Mount
Universal frame mount brake pedal assembly for GM style brake booster with 4 bolt 3-3/8? center. For automatic transmission equipped, left hand drive hot rod and truck models. Great for under the floor, frame mount...
1965-70 Impala, Bel Air, Biscayne, Caprice; Clutch Bellcrank Assembly; Small Block and Big Block
Precision reproduction of the original bellcrank assembly for use with all 1965-70 Chevrolet Impala, Bel Air, , Biscayne, and Caprice models with small block or big block engines. Each bellcrank is designed to OE...
1958-79 Chevrolet; Flywheel Clutch Housing Cover; for 10-1/2" Bellhousing; Manual Trans; OER
Correct flywheel / clutch cover plate designed for use with the various 1958-79 Chevrolet models as listed. Each cover is manufactured in quality stamped steel for an authentic replacement. This cover is located on the back...
1965-66 Impala, Caprice, Bel Air, Biscayne; Pedal Assembly Set; Brake & Clutch
Reproduction clutch and brake pedal assembly for 1965-66 Chevrolet Impala and full-size models. This brake and clutch pedal assembly is manufactured in quality stamped steel construction that closely replicates the original...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...