1964-1981 Chevrolet; Clutch Housing / Flywheel Cover ; for 11" Bellhousing
Reproduction of the original style clutch housing and flywheel cover plate designed for use on a variety of 1964-81 Chevrolet models as listed. Manufactured in stamped steel to original specifications that replicate the...
1962-64 Impala, Bel Air, Biscayne; Clutch Bellcrank; V8; with Manual Transmission
Precision reproduction of the bellcrank assembly, also known as the clutch cross shaft, for all 1962-64 Chevrolet full size models with V8 and manual transmission (except models equipped with 348ci or 409 ci engines). Does...
1958-79 Chevrolet; Flywheel Clutch Housing Cover; for 10-1/2" Bellhousing; Manual Trans; OER
Correct flywheel / clutch cover plate designed for use with the various 1958-79 Chevrolet models as listed. Each cover is manufactured in quality stamped steel for an authentic replacement. This cover is located on the back...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
1963-64 Impala, Biscayne, Bel Air; Pedal Assembly Set; Brake & Clutch
Reproduction clutch and brake pedal assembly for 1963-64 Chevrolet Impala, Biscayne, and Bel Air models. This brake and clutch pedal assembly is manufactured in quality stamped steel construction closely replicating the...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...