Reproduction of the original convertible top cylinder designed for use with 1962 Buick, Cadillac, Chevrolet, Pontiac, and Oldsmobile full size convertible models. All convertible top cylinders are not the same. This...
Reproduction of the original hydraulic hose set designed for use with a wide variety of convertible models as listed. Finding an original hose for your early convertible is next to impossible. If you own a convertible model...
1955-72 Buick, Chevy, Pontiac, Oldsmobile, Full Size; Convertible Top Hydraulic Pump Seal Set
Hydraulic pump seal set designed for use with the various 1955-72 GM Full Size convertible models listed. This set contains 2 large O-rings. Depending on the year of your car, only 1 may be required. These large O-rings seal...
1955-72 Camaro, Firebird, Impala, Nova; Convertible Top Hose Retainer; Push In Style
Reproduction of the original hose retainer clip designed for use with 1967-69 GM convertible models. Each clip is manufactured in stamped steel and heat treated for extra strength. This clip is designed to retain the...
1967-69 Camaro, Firebird; Convertible Top Boot Interior Snaps with Screws; 4 Piece Set
Reproduction convertible top boot snap and screw set for 1967-69 Camaro and Firebird models and any other vehicle that requires a screw-on style snap. These snaps are used to secure the convertible top to the inner rear...
Reproduction convertible top motor & pump assembly made to provide consistent hydraulic pressure and dependability. Raise and lower the power top with ease by replacing the old or worn out original. The motor comes complete...
1949-75 GM, Dodge, Plymouth; Convertible Top Rear Window Binding End Clip, with Screw
OER reproduction of the original convertible top rear binding end clip that was used for most 1949-75 GM, Dodge, and Plymouth convertible models. This stainless steel end clip covers covers and finishes both ends of the rear...