1967 F-Body Frame Side Clutch Pivot Ball Bracket
OER® Reproduction of the frame side clutch pivot ball bracket. Features the correct offset and holes as original and is used for L6, small block and big block models. Applications 1967 Camaro 1967 Firebird You...
1958-88 Buick, Chevrolet, Pontiac, Oldsmobile; Clutch Bell Crank Z-Bar Pivot Bushing Set
This is The plastic clutch bell crank or Z bar insert set that allow the bar to pivot. These are present on most all GM cars from 1958-88 with a manual transmission. This four piece set which includes 3 nylon bushings and a...
1967-70 Camaro Shift Plate Retainer ; w/o Console ; Manual Transmission
Reproduction of the original GM shift boot and plate retainer for use on all 1967-70 Chevrolet Camaro models 4 speed manual transmissions without a floor console. This retainer is manufactured in stamped steel and used to...
1962-76 Mopar A, B, E-Body; Bell Crank Linkage Spring Clip; Each;
Reproduction of the original clutch bell crank linkage spring clip designed for use on almost all 1962-76 Mopar A, B and E-Body vehicles. The clip is manufactured to replicate the original in every detail using factory...
1969 Camaro Hurst Shifter Lever Hardware
Reproduction of the original 1969 Camaro Hurst shift lever hardware designed to replace broken, damaged or worn out originals. Includes high strength steel bolts and washers as shown.
1970-81 Clutch Bellcrank Pivot Ball Bracket ; Frame Side ; Camaro. Firebird
OER® reproduction of the original frame side clutch bellcrank pivot ball bracket designed for use on 1970-81 Camaro and Firebird models with manual transmissions. This steel bracket attaches to the vehicles frame....
1964-67 Impala, Caprice, Nova; Muncie Shifter to Hurst Shifter Conversion Adapter Bracket
This bracket adapts a factory GM Muncie shifter arm to a Hurst Competition Plus shifter mechanism. Installing this bracket combines the classic look of an OE Muncie shifter with performance and reliability of a Hurst shift...
1953-2010 GM; Rear Axle/Transmission Ventilator; for 3/8" Hole
OER® reproduction of the ventilator used by GM on a multitude of applications from the 1950s thru todays cars and trucks including the rear axle housing, automatic transmissions. front transfer case on 4 x 4 models and...