Rubber Floor Pan Plug; 1-1/4" Diameter. Fits 1" Hole; Each
Reproduction rubber floor pan plug measures 1-1/4" diameter and fits a 1" hole. Sold individually, use as required.
1958-84 GM; Outer Rear Hood Rubber Stoppers; Pair; Various Models
Reproduction outer rear hood bumpers for various GM models. Each bumper is manufactured to quality EPDM rubber compound and matches the original in dimensions allowing proper fitment. Sold in pairs. Use as required Buick...
1968-81 Camaro, Impala, Firebird; Door Glass Guide Stop Bumpers; Pair; Various GM
Reproduction of the original door glass guide stop bumpers designed for use with various 1968-81 General Motors vehicles. These glass guide stops are required for proper door glass alignment. Commonly damaged during removal...
1987-2016 GM; Rear Trunk Lid Access Hole Plug; Each; Various Models
Reproduction trunk lid drain hole plug for 1987-2016 GM vehicles including 1991-96 Impala and Caprice models. Manufactured from molded rubber as original, these install on the underside of the trunk lid. Measures 9/165"...
1958-77 Buick, Chevy, Olds, Pontiac; Hood Adjust Bumper and Screw Set; Various Models
Reproduction hood adjustment bumpers for various 1958-77 GM models including 1967-69 Camaro and Firebird models. These 7/8" OD reproduction stoppers and screws are manufactured to original specifications to replace the worn...
1980-90 Impala, Caprice, Bonneville; Hood Side Rubber Bumper; Each
Reproduction of the rubber hood side bumper designed for use on all 1980-90 Impala, Caprice, Bonneville and Pontiac Full Size models. Each rubber stopper is manufactured in the correct configuration from quality rubber same...
1955-1981 GM; Firewall Pad Fastener; Each
This reproduction firewall pad fastener is designed to hold the firewall insulation pad in place on various 1955-81 General Motors models. Each fastener is manufactured from EPDM rubber replicating the original configuration...
1951-72 Buick, Chevrolet, Pontiac, Oldsmobile; Convertible Power Top Motor Mounting Grommet; Each
Reproduction of the original rubber mounting/insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a damper...
1970-90 GM; Lower Door Window Stop Bumper; Each; Various Models
Correct reproduction rubber stop bumper designed to keep the door glass from rolling down beyond the required travel point. Each stopper is manufactures from quality EPDM rubber and features a press fit retaining tab for easy...
1977-2005 Buick, Chevy, Olds, Pontiac; Compartment Lid Rubber Bumper; Front or Rear; Each
Reproduction of the original rear compartment lid rubber stopper needed to prevent the rear compartment lid from slamming against the body. Each rubber bumper is manufactured in quality EPDM rubber that replicates the...
1958-72 Buick, Chevy, Olds, Pontiac; Trunk Lid Rubber Stopper; Each; Various Models
Correct OER® reproduction of the original trunk lid rubber bumpers designed for use with various 1958-72 GM models. These rubber bumpers are engineered to replicate the factory originals in design, fit, and function. Each...
1970-87 Buick, Chevrolet, Olds, Pontiac; Upper Control Arm Bumper; Various Models; Each
Reproduction control arm bumper for Buick, Chevrolet, Oldsmobile, and Pontiac models. This upper control arm bumper is designed to replicate the factory original and is essential for proper suspension travel and ride control....