Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
1955-59 Brake or Clutch Pedal Pad Chevrolet / GMC Truck
OER® reproduction of the original brake and clutch pedal pad designed for use on 1955-59 Chevy/GMC truck models. Brake design is same as original including correct ribbed design. For use on 2nd design 1955 models with...
Reproduction brake and clutch pedal pad for various 1964-1991 Buick, Chevy, Pontiac, and Oldsmobile models with manual transmissions. Each pedal pad is manufactured in EPDM rubber to factory specifications and replicates the...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1962-67 Chevrolet; Brake or Clutch Pedal Pad; without Power Brakes; Each
Reproduction of the original brake and clutch pad designed for use on various GM models with a manual transmission and standard brakes. Each pad is manufactured in quality RPDM rubber replicating the original in quality and...
1947-55 Chevrolet, GMC Pickup Truck; Brake or Clutch Pedal Pad; Each
OER® reproduction of the original brake or clutch pedal pad for 1947-55 Chevy and GMC truck models. Manufactured to exact specifications and includes correct configuration for originality. For use with 1955 1st Series...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...