Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 Buick, Chevrolet, Pontiac, Oldsmobile; Door Lock Gasket; Each; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1964-79 Camaro, Chevelle, Firebird, Nova, X-Body; Outer Door Handle Gasket Set; Various Models
Reproduction of the original outer door handle gasket set designed to properly seal the exterior door handles on various classic vehicle applications. Each set includes precision die-cut gaskets manufactured to factory...
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1967-69 Camaro, 1968-72 Chevy II, Nova; Hood Louver Gasket; Each
Reproduction of the original hood louver gaskets that seal the hood louvers to the hood. These gaskets are manufactured to precisely replace the old or worn originals. Prevents water and other elements from seeping past the...
1966-72 Chevrolet; Standard Door Mirror Gasket
Quality reproduction outer door mirror gasket for various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors. Installs between the mirror base and...
Outer Door Bullet Mirror Gasket ; 1970-81 Camaro / Firebird, 1973-74 Nova
Correct reproduction of the original outer door bullet mirror gasket designed for use on various GM models. This gasket separates the mirror base from the outer door metal. For use with bullet style mirrors in the various...
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
1970-81 Camaro, Firebird, Nova, Ventura; Upper Clutch Push Rod Boot; Various Models
OER® reproduction upper clutch push rod boot for various 1970-81 Buick, Chevrolet, Oldsmobile, and Pontiac models. Each boot is manufactured using high-quality EPDM automotive-grade rubber to replicate the original in...
1968-76 Remote Outer Door Mirror Gasket ; Various Models
Reproduction of the original outer door remote mirror mounting gasket for use with the various applications listed. Each gasket is manufactured to replicate the original is fitment and design. Can be used with the original...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
Reproduction license plate / fuel door stoppers for the rear license bracket. These are OE type reproductions manufactured to exact OE specifications. Sold in pairs. 9/16" diameter, 13/16" tall. GM Note: REV. 5-80 (cut 1/4"...
1967-74 Upper Clutch Push Rod Boot - Various Models
This OER® reproduction of the original upper push rod molded rubber boot is manufactured using correct E.D.P.M. rubber compound stock that is superior to the original. Molded in steel insert distributes mounting screw...
1962-78 Nova, Camaro, Firebird, Impala, Truck; Speedometer Cable Firewall Grommet; w/Steel Insert
Quality reproduction of the original speedometer cable firewall grommet designed for use on various 1962-73 Chevy II Nova, Camaro, Impala, Bel Air, Biscayne, Caprice, Firebird, and 1973-78 Chevrolet, GMC truck models as...
1954-1981 GM; Hood Adjustor Rubber Bumper & Stud; Various GM Cars & Trucks
Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...
1968-72 Chevy II / Nova Vent Frame Weatherstrips, 2 Door, Pair
Reproduction of the original molded vent window seals designed for use on 1968-72 Chevy II / Nova and X-Body, 2 door models. MEach weatherstrip is manufactured of durable rubber for an authentic appearance and original fit....
Correct reproduction of the original power window harness rubber boots which is used to house the power window wiring harness as it passes between the door jamb and door area. This rubber boot is manufactured in durable...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
1966-70 Evaporator Case Drain Hose Rubber Seal - with AC
OER® reproduction of original evaporator case drain hose that attaches to the bottom portion of the evaporator core outlet case on various 1966-70 GM models originally equipped with air conditioning. Each drain hose is...
1961-79 GM; Transmission Control Cable Grommet; OER
OER® reproduction of the original GM transmission control cable grommet for all 1961-79 GM models. Designed to factory specifications in the correct configuration for a perfect fit and manufactured in rubber as original....
Reproduction of the original outer door handle and door lock gasket set designed to properly seal and protect the exterior door handle and lock areas on various vehicle models. Each gasket is precision die-cut to factory...