Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1970-88 Buick, Chevrolet, Oldsmobile, Pontiac; Outer Door Handle Gasket; LH or RH ; Each
Reproduction door handle gasket for 1970-81 GM F-Body and 1973-88 G-Body models. This gasket inserts on the back of the outer door handle and acts as protection between the handle and the paint. Sold individually. 2 gaskets...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper ; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
1954-1981 Hood Adjustor Bumper and Stud - Various GM vehicles
Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...
1961-79 GM; Speedometer Cable Firewall Grommet; OER
OER® reproduction of the original GM speedometer cable grommet for all 1961-79 GM models. Designed to factory specifications in the correct configuration for a perfect fit and manufactured in rubber as original. Will...