1964-72 Buick, Chevrolet, Oldsmobile, Pontiac; Fuel Tank Vent Tube Grommet; Each
Replacement vent tube grommet for 1964-72 GM models. Manufactured to factory dimensions, this molded rubber grommet fits in the trunk pan and features two holes for the fuel vent tube to pass through. {fitment}
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 GM; Door Lock Gasket; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1964-79 GM; Door Handle Gasket Set; Outer; Various Models
This reproduction gasket set includes a complete set of door handle gaskets used to install the outer door handles on the various models listed below. Each set includes correct die-cut gaskets for both RH and LH outer door...
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1966-72 Chevrolet; Standard Door Mirror Gasket
Quality reproduction outer door mirror gasket for various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors. Installs between the mirror base and...
Restore proper protection to your engine compartment with these factory-style OER reproduction splash apron flaps. Designed and manufactured to OE specifications, each apron set delivers an authentic fit and appearance while...
1970-88 Buick, Chevrolet, Oldsmobile, Pontiac; Outer Door Handle Gasket; LH or RH ; Each
Reproduction door handle gasket for 1970-81 GM F-Body and 1973-88 G-Body models. This gasket inserts on the back of the outer door handle and acts as protection between the handle and the paint. Sold individually. 2 gaskets...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1968-76 Remote Outer Door Mirror Gasket ; Various Models
Reproduction of the original outer door remote mirror mounting gasket for use with the various applications listed. Each gasket is manufactured to replicate the original is fitment and design. Can be used with the original...
Protect your engine bay from water, salt, and road debris with these OER reproduction splash aprons. Each superior reproduction set is manufactured to original specifications, ensuring the correct fit and appearance. Designed...
1968-72 Shift Plate Seal Set ; Chevelle, El Camino, Monte Carlo ; 4 Piece Set
Reproduction of the original shift plate seals designed for use on 1968-72 Chevelle models with automatic transmissions. These seals are manufactured from die cut high grade rubber and will fit as original. 4 piece set....
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
1954-1981 GM; Hood Adjustor Rubber Bumper & Stud; Various GM Cars & Trucks
Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...
1964-65 Chevelle, El Camino; Front Fender Well Splash Apron Set; RH & LH; Pair
Replace the worn or missing splash aprons on your inner fender wells with this authentic OER reproduction set. Designed and manufactured to factory specifications, these premium splash aprons restore the correct seal between...
1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER
Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...
1961-79 GM; Transmission Control Cable Grommet; OER
OER® reproduction of the original GM transmission control cable grommet for all 1961-79 GM models. Designed to factory specifications in the correct configuration for a perfect fit and manufactured in rubber as original....
1973-81 Chevy, GMC Pickup, Blazer, Jimmy, Suburban; Hood Bumpers; 8 Piece Set
Reproduction of the original hood bumpers for 1973-81 Chevrolet & GMC pickup, Blazer, Jimmy, and Suburban models. Manufactured in quality EPDM rubber to factory dimensions for an authentic appearance and fitment. Set...