This is The plastic clutch bell crank or Z bar insert set that allow the bar to pivot. These are present on most all GM cars from 1958-88 with a manual transmission. This four piece set which includes 3 nylon bushings and a...
1967 F-Body Frame Side Clutch Pivot Ball Bracket
OER® Reproduction of the frame side clutch pivot ball bracket. Features the correct offset and holes as original and is used for L6, small block and big block models. Applications 1967 Camaro 1967 Firebird You are assured...
1967-70 Camaro; Shift Plate Retainer; without Floor Console; with Manual Transmission
Reproduction of the original GM shift boot and plate retainer for use on all 1967-70 Chevrolet Camaro models 4 speed manual transmissions without a floor console. This retainer is manufactured in stamped steel and used to...
1969 Camaro Hurst Shifter Lever Hardware
Reproduction of the original 1969 Camaro Hurst shift lever hardware designed to replace broken, damaged or worn out originals. Includes high strength steel bolts and washers as shown.
1970-81 Clutch Bellcrank Pivot Ball Bracket ; Frame Side ; Camaro. Firebird
OER® reproduction of the original frame side clutch bellcrank pivot ball bracket designed for use on 1970-81 Camaro and Firebird models with manual transmissions. This steel bracket attaches to the vehicles frame....