1967 F-Body Frame Side Clutch Pivot Ball Bracket
OER® Reproduction of the frame side clutch pivot ball bracket. Features the correct offset and holes as original and is used for L6, small block and big block models. Applications 1967 Camaro 1967 Firebird You are assured...
Reproduction clutch bell crank (Z-bar) pivot stud nylon seat and retainer set for 1958-88 Chevrolet, Buick, Oldsmobile, and Pontiac models equipped with a manual transmission. These plastic inserts allow the clutch bell crank...
1967-70 Camaro; Shift Plate Retainer; without Floor Console; with Manual Transmission
Reproduction of the original GM shift boot and plate retainer for use on all 1967-70 Chevrolet Camaro models 4 speed manual transmissions without a floor console. This retainer is manufactured in stamped steel and used to...
1969 Camaro Hurst Shifter Lever Hardware
Reproduction of the original 1969 Camaro Hurst shift lever hardware designed to replace broken, damaged or worn out originals. Includes high strength steel bolts and washers as shown.
1970-81 Clutch Bellcrank Pivot Ball Bracket ; Frame Side ; Camaro. Firebird
OER® reproduction of the original frame side clutch bellcrank pivot ball bracket designed for use on 1970-81 Camaro and Firebird models with manual transmissions. This steel bracket attaches to the vehicles frame....
1953-2010 GM; Rear Axle / Transmission Ventilator; for 3/8" Hole
OER® reproduction of the original style ventilator used by GM on a wide range of applications from the 1950s through present-day cars and trucks. This ventilator is designed for use on rear axle housings, automatic...
1972-81 Camaro; Clutch Linkage Set; Small block & Big Block
Reproduction of the original clutch linkage components designed to replace the clutch linkage on 1972-81 Camaro small block or big block models. Each comprehensive clutch linkage set includes the necessary components to...
1963-74 Chevrolet; Retainer Clip; for Transmission Back-Up Switch Wire; Cushioned, Insulated
Replacement back-up lamp switch wire harness retaining clip for models with a muncie transmission. This clip mounts the reverse back-up lamp switch wire harness to the bellhousing. This is an exact reproduction of the...