1955 Chevy Passenger Car; Rear Bumper To Body Seal Strip
Reproduction rear bumper to body seal for 1955 Chevrolet Tr-Five models. Each body seal is manufactured to original factory specifications. Features the correct length and shape for an authentic replacement. Applications:...
1957 Chevrolet Passenger Car; Rear Bumper To Body Seal
Reproduction of the original rear bumper to body seal designed for use on 1957 Chevrolet Tr-Five models. Each body seal is manufactured to original factory specifications. Features the correct length and shape for an...
1955-57 Chevrolet Bel Air, 150, 210; Spare Tire Well Plug; Each
Reproduction of the original spare tire body plug designed for use with 1955-57 Chevrolet models. Each rubber plug is manufactured in EPDM rubber replicating the original configuration. Sold individually. Use as required....
1956 and 1958 Chevrolet Passenger Car; Rear Bumper to Body Seal
Reproduction of the original rear bumper to body seal designed for 1956 and 1958 Chevrolet full size passenger car models. Each body seal is manufactured to factory specifications from molded EPDM rubber. {fitment}
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 GM; Door Lock Gasket; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1966-72 Chevrolet; Standard Door Mirror Gasket
Quality reproduction outer door mirror gasket for various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors. Installs between the mirror base and...
1963-65 Chevrolet; Door Mirror Gasket ; LH or RH ; Various Models
Quality reproduction of the original outer door mirror gasket designed for use on various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors....
1957-58 Chevrolet Full Size Passenger Car; Radiator Core Support Wiring Grommet
Reproduction radiator core grommet for 1957-58 Chevrolet passenger car models. This grommet is used to guide the wiring harness through the radiator core support and installs in the driver side of the core support panel....
1970-88 Buick, Chevrolet, Oldsmobile, Pontiac; Outer Door Handle Gasket; LH or RH ; Each
Reproduction door handle gasket for 1970-81 GM F-Body and 1973-88 G-Body models. This gasket inserts on the back of the outer door handle and acts as protection between the handle and the paint. Sold individually. 2 gaskets...
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1961-64 Impala, 1961-62 Bel Air; U Shape Door Jamb Rubber Seals, with Screws; Pair
Correct reproduction of the of the original U-shaped rubber door jamb rubber seals designed for use on 1961-64 GM Impala 2 door hardtop models. Each U-shape seal is manufactured to original specifications including a steel...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
Reproduction door frame weatherstrip set for Chevrolet Impala and other GM Full Size 2-door hardtop and convertible models. This reproduction is designed to replace the original exactly featuring the correct molded ends and...
1968-76 Remote Outer Door Mirror Gasket ; Various Models
Reproduction of the original outer door remote mirror mounting gasket for use with the various applications listed. Each gasket is manufactured to replicate the original is fitment and design. Can be used with the original...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....