1962 Impala; Tail Panel Cove Moldings; with Hardware; Pair
Correct reproduction of the original tail lamp cove moldings for 1962 Impala and Full size Chevrolet models. These polished aluminum moldings attach to the quarter panel and act as an extension of the trunk lid molding....
1962 Impala, Bel Air; Upper Trunk Lid Molding; with Clips
Reproduction of the upper trunk lid molding designed for use on 1962 Impala and Bel Air Chevrolet models. Trunk lid molding fits on the rear upper section of the trunk lid. Each molding is contoured and stamped in quality...
1964 Impala, Bel Air, Biscayne; Center Rear Cove Molding; Standard Models
Reproduction of the original rear cove center panel molding designed for use on 1964 Impala and Full Size Chevrolet models with factory standard trim level. Each molding is stamped from quality aluminum material in the...
1964 Impala, Bel Air; Trunk Center Molding; Trunk Spear; with Hardware
Reproduction of the original Chevrolet Impala or Bel Air center trunk split molding designed for use on 1964 models. This center trunk molding runs down the center of the trunk lid and sections off the RH from the LH sides....
1964 Impala SS, Bel Air, Biscayne; Upper Trunk Lid Molding; Except Station Wagon
Reproduction of the original upper trunk molding designed for use with 1964 Impala SS, Bel Air, and Biscayne models. Each molding is manufactured in bright finished stamped aluminum replicating the original contour and...
1964 Impala SS; Bel Air; Lower Trunk Lid Molding; except Station Wagon
Reproduction of the original lower trunk molding designed for use with 1964 Bel Air, and Impala SS models. Each molding is manufactured in stamped aluminum replicating the original contour and factory design. Will replace the...
Reproduction of the original outer tail cove moldings designed for use with 1964 Impala SS, Bel Air and Biscayne models. Each molding is manufactured in bright finished stamped aluminum replicating the original contour and...
1964 Impala SS; Bel Air; Inner Tail Cove Moldings; with Hardware; Pair
Reproduction of the original inner tail cove moldings designed for use with 1964 Impala SS and Bel Air models. Each molding is manufactured in stamped aluminum replicating the original contour and factory design. Will replace...
1963 Impala, Bel Air; Rear Corner Cove Moldings; with Hardware; Pair
Reproduction rear outer corner cove moldings for 1963 Chevrolet Impala, Bel Air, and Biscayne models. Manufactured in quality stamped aluminum to OE specifications. These polished aluminum moldings act as an extension of the...