Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head
Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...
Flat Washer; 1/2" USS; Zinc Plated
1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...
1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon
Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...
Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate
OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...
1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each
Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...
1955-59 Chevy, Ford; Windshield Wiper Blade; 12"; Triple-Action; Wrist-Action Connector; Stainless
Reproduction windshield wiper blade 2nd design 1955 models, and all 56-59 truck models. This blade is also correct replacement for a wide variety of other makes and models, including 1955-57 GM Passenger models Bel Air, 150,...
1965-70 Impala, Electra, LeSabre, Wildcat; Convertible Top Front Header Bow
Reproduction of the original convertible top header bow designed for use with various 1965-70 Buick, Chevrolet, Pontiac, Oldsmobile, and Pontiac full size convertible models. Each header bow is manufactured in stamped steel...
1959-60 Impala / Full-Size 2/4 Door Hardtop/Convertible Windshield - Clear
Replacing your original damaged or missing windshield glass will enhance your vehicle's appearance and safety by allowing you to see clearly. Don't settle for anything less than original quality glass when replacing the...
1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Vinyl Storage Bag
Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot vinyl storage bag. The storage bag will help protect your vehicles top boot while being stored in...
1970-81 Camaro, Firebird, Impala; Upper Front Door Hinge; Passenger Side; Various Models
This OER® reproduction door hinge will allow your door to work properly again! The 1970-81 doors were extremely heavy and hard on the original hinges. A new set of hinges will help your doors to open and close the way the...
U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each
Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...
Reproduction back window glass for various Buick, Cadillac, Chevy, Oldsmobile, and Pontiac 2 door hardtop models. Each rear window glass is manufactured to factory specifications featuring correct glass shape and contours for...
Reproduction of the original front windshield glass for use with 1969-70 Buick, Chevy, Pontiac, Oldsmobile Full Size models as listed. This windshield is manufactured with tempered laminate safety glass that meets the...
1965-70 Impala, GM Convertible; Rear Window Glass; Light Green Tint
Reproduction back window glass for various 1965-70 Buick, Cadillac, Chevy, Oldsmobile, and Pontiac Full Size convertible models. Each rear window glass is manufactured in tempered glass to factory specifications featuring...
3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each
Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...
OER reproduction front windshield glass for use with various 1971-76 Buick, Chevrolet, Pontiac, and Oldsmobile B and C Body 2 & 4 door, hardtop, sedan, and station wagon models. This windshield is manufactured with tempered...
Windshield Wiper Blades; Aero Style; 15"; for 1/4" (7mm) Bayonet Style Arms; Pair; Various Models
High quality reproduction of the stainless steel "Aero" Anti Wind-Lift Wiper Blades designed to fit 7mm wide bayonet style wiper arms. Popularized in the 1960's and 70's to combat wind lift at high speeds, these 15 inch wiper...
Reproduction of the original convertible top cylinder designed for use with 1965-1970 Buick, Cadillac, Chevrolet, Pontiac, and Oldsmobile full size convertible models. All convertible top cylinders are not the same. This...
Reproduction of the original front windshield glass for use with 1963-64 Buick, Chevrolet, Pontiac, and Oldsmobile Full Size 2 & 4 door hardtop, and convertible models as listed. This windshield is manufactured with tempered...
Reproduction of the original front windshield glass for use with 1969-70 Buick, Chevy, Pontiac, Oldsmobile Full Size models as listed. This windshield is manufactured with tempered laminate safety glass that meets the...