1964-72 Buick, Chevrolet, Oldsmobile, Pontiac; Fuel Tank Vent Tube Grommet; Each
Replacement vent tube grommet for 1964-72 GM models. Manufactured to factory dimensions, this molded rubber grommet fits in the trunk pan and features two holes for the fuel vent tube to pass through.
Reproduction roof rail weatherstrip channel set for 1970-72 Chevrolet Chevelle, Buick Skylark, and Gran Sport (GS) 2-door hardtop models. Manufactured to factory specifications, this 6-piece stainless steel set installs along...
Reproduction roof rail weatherstrip channel set for 1966-67 Chevrolet Chevelle, Pontiac GTO, Tempest, LeMans, Buick Skylark, Gran Sport, and Oldsmobile 442, Cutlass, and F85 2-door hardtop models. Manufactured to factory...
Reproduction roof rail weatherstrip channel set for 1964-65 Chevrolet Chevelle, Oldsmobile Cutlass, F85, and Buick Skylark 2-door hardtop models. Manufactured to factory specifications, this 6-piece stainless steel set...
Reproduction roof rail weatherstrip channel connectors for 1968-72 Chevrolet Chevelle, Pontiac GTO, Tempest, LeMans, Buick Skylark, Oldsmobile 442, Cutlass, F85, and 1970-72 Chevrolet Monte Carlo 2-door hardtop models....
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 Buick, Chevrolet, Pontiac, Oldsmobile; Door Lock Gasket; Each; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1964-79 Camaro, Chevelle, Firebird, Nova, X-Body; Outer Door Handle Gasket Set; Various Models
Reproduction of the original outer door handle gasket set designed to properly seal the exterior door handles on various classic vehicle applications. Each set includes precision die-cut gaskets manufactured to factory...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1970-88 Buick, Chevrolet, Oldsmobile, Pontiac; Outer Door Handle Gasket; LH or RH; Each
Reproduction of the original outer door handle gasket designed for use with 1970-81 GM F-Body and 1973-88 GM G-Body models. This gasket installs on the backside of the exterior door handle to provide a protective barrier...
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
1970-81 Camaro, Firebird, Nova, Ventura; Upper Clutch Push Rod Boot; Various Models
OER® reproduction upper clutch push rod boot for various 1970-81 Buick, Chevrolet, Oldsmobile, and Pontiac models. Each boot is manufactured using high-quality EPDM automotive-grade rubber to replicate the original in...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1954-1981 GM; Hood Adjustor Rubber Bumper & Stud; Various GM Cars & Trucks
Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...
1982-98 Buick, Cadillac, Chevrolet, Oldsmobile, and Pontiac; Door Jamb Switch Seal
Reproduction door jamb switch seal for the door jamb switch on a wide variety of GM models. Manufactured in rubber like the original, this accordian style seal prevent the elements from entering into the door jamb switch...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
1958-72 Buick, Chevy, Olds, Pontiac; Trunk Lid Rubber Stopper; Each; Various Models
Correct OER® reproduction of the original trunk lid rubber bumpers designed for use with various 1958-72 GM models. These rubber bumpers are engineered to replicate the factory originals in design, fit, and function. Each...
1961-79 GM; Transmission Control Cable Grommet; OER
OER® reproduction of the original GM transmission control cable grommet for all 1961-79 GM models. Designed to factory specifications in the correct configuration for a perfect fit and manufactured in rubber as original....
Reproduction of the original outer door handle and door lock gasket set designed to properly seal and protect the exterior door handle and lock areas on various vehicle models. Each gasket is precision die-cut to factory...