Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head
Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...
Flat Washer; 1/2" USS; Zinc Plated
1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...
1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon
Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...
Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate
OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...
1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each
Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...
1955-59 Chevy, Ford; Windshield Wiper Blade; 12"; Triple-Action; Wrist-Action Connector; Stainless
Reproduction windshield wiper blade 2nd design 1955 models, and all 56-59 truck models. This blade is also correct replacement for a wide variety of other makes and models, including 1955-57 GM Passenger models Bel Air, 150,...
1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Vinyl Storage Bag
Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot vinyl storage bag. The storage bag will help protect your vehicles top boot while being stored in...
U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each
Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...
1973-77 Regal; Cutlass; Monte Carlo; El Camino; LeMans; Body Mount Bushing Set; 28 piece
Reproduction 28 piece body mount bushing set for various 1973-77 GM models. Manufactured to factory specifications for proper fitment and function. These kits are made out of compression molded S.B.R. with steel sleeve...
3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each
Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...
Reproduction windshield glass for various 1973-77 GM A-Body 4-door sedan and station wagon models. This windshield is manufactured with tempered laminate safety glass that meets the standard for protection against road...
Replace the worn or rusted out rear convertible tack strip bow or rear tacking rail with this quality reproduction. This 3 piece tack strip also known as a trimstick, mounts below the rear window area inside the trunk and...
OER reproduction of the front windshield glass for use with 1973-77 GM A-Body 2-door coupe models without the built-in antenna. This windshield is manufactured with tempered laminate safety glass that meets the standard for...
Wiper Blade Insert; Replacement; 16" Anco Style; Each
OER reproduction Anco-style windshield wiper blade insert for various classic American vehicle models from the 1960's and up. These 16" wiper blades are manufactured from quality molded rubber as original. Refill is...
New power window motor for various GM passenger car and truck models. Manufactured to factory specifications for an original fit and function. This original style power window motor was used in wide variety of GM models....
1984-87 Buick, Chevrolet, GMC, Oldsmobile, Pontiac; Windshield Wiper Motor; 2 Terminal; Brand New
Brand New Reproduction wiper motor built using the industry's most advanced engineering technology. Core shortages and low availability have made our brand new replacement wiper motors the high quality, low cost alternative...
1982-94 Buick, Cadillac, Chevy, Pontiac, Olds; Exterior Door Handle; Black; RH; Various Models
Reproduction exterior door handle for a wide variety of GM models including Buick, Cadillac, Chevrolet, Oldsmobile, and Pontiac. Produced in die-cast metal with a glossy black coating, these handles are typically designed to...
16" Windshield Wiper Blade Refill; Pair; 16" x 3/8" wide
Reproduction of the windshield wiper blade inserts for various models equipped with 16" wiper blades. Each blade insert is manufactured for perfect fit, function and appearance when used with the proper blade assembly....
Reproduction of the original style power sindow lift motor for use with various 1979-2005 GM models as listed. Return your power windows to good working order by replacing your missing or nonfunctional original with this new...