Universal Frame Mount Manual Brake Pedal Bracket Assembly; GM Booster Style; Under Floor Mount
Universal frame mount brake pedal assembly for GM style brake booster with 4 bolt 3-3/8? center. For automatic transmission equipped, left hand drive hot rod and truck models. Great for under the floor, frame mount...
Reproduction cluch fork for 1957-62 Chevrolet Bel Air, 150, 210, Impala, and Biscayne and 1955-62 Corvette models with manual transmission. It may also be used in 4-speed conversions with an original cast iron bellhousing...
1962-79 GM; Flywheel Clutch Housing Cover; for 10-1/2" Bellhousing; Manual Trans; OER
Correct flywheel / clutch cover plate designed for various 1962-79 GM models. Each cover is manufactured in quality stamped steel for an authentic replacement. This cover is located on the bellhousing and is used to cover the...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
1955-62 Bel Air/Impala Clutch Fork Rod And Return Spring
Reproduction clutch for push rod and return spring set for 1957-62 Bel Air and Impala models. This connects the clutch fork to the bellcrank (Z-bar). Measurement: Full Length: 11 3/8" long Thread to Eye: 11" long Diameter:...
1958-63 Chevrolet; Brake and Clutch Pedal Pad; With Manual Trans; Various Models
Reproduction brake and clutch pedal pad for various 1958-63 Chevrolet models with manual transmissions. Each pedal pad is manufactured in EPDM rubber to factory specifications and replicates the original in quality and...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...