1956 & 1958 Chevy Bel Air, 150, 210, Impala, Biscayne; Rear Bumper to Body Seal Weatherstrip
Reproduction of the original rear bumper to body seal designed for 1956 and 1958 Chevrolet full size passenger car models. Each body seal is manufactured to factory specifications from molded EPDM rubber.
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 Buick, Chevrolet, Pontiac, Oldsmobile; Door Lock Gasket; Each; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1966-72 Chevrolet; Standard Door Mirror Gasket
Quality reproduction outer door mirror gasket for various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors. Installs between the mirror base and...
1957-58 Chevrolet Bel Air, 150, 210, Nomad; Radiator Core Support Wiring Grommet
High-quality reproduction radiator core grommet designed for 1957-58 Chevrolet passenger car models. This grommet routes and protects the wiring harness as it passes through the radiator core support, preventing abrasion and...
1970-88 Buick, Chevrolet, Oldsmobile, Pontiac; Outer Door Handle Gasket; LH or RH; Each
Reproduction of the original outer door handle gasket designed for use with 1970-81 GM F-Body and 1973-88 GM G-Body models. This gasket installs on the backside of the exterior door handle to provide a protective barrier...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1968-76 Remote Outer Door Mirror Gasket ; Various Models
Reproduction of the original outer door remote mirror mounting gasket for use with the various applications listed. Each gasket is manufactured to replicate the original is fitment and design. Can be used with the original...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
1982-98 Buick, Cadillac, Chevrolet, Oldsmobile, and Pontiac; Door Jamb Switch Seal
Reproduction door jamb switch seal for the door jamb switch on a wide variety of GM models. Manufactured in rubber like the original, this accordian style seal prevent the elements from entering into the door jamb switch...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
1966-70 Evaporator Case Drain Hose Rubber Seal - with AC
OER® reproduction of original evaporator case drain hose that attaches to the bottom portion of the evaporator core outlet case on various 1966-70 GM models originally equipped with air conditioning. Each drain hose is...
1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER
Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...
1961-79 GM; Transmission Control Cable Grommet; OER
OER® reproduction of the original GM transmission control cable grommet for all 1961-79 GM models. Designed to factory specifications in the correct configuration for a perfect fit and manufactured in rubber as original....
Reproduction of the original outer door handle and door lock gasket set designed to properly seal and protect the exterior door handle and lock areas on various vehicle models. Each gasket is precision die-cut to factory...