Rubber Floor Pan Plug; 1-1/4" Diameter. Fits 1" Hole; Each
Reproduction rubber floor pan plug measures 1-1/4" diameter and fits a 1" hole. Sold individually, use as required.
1992-02 Camaro, Firebird, Corvette; Inner Quarter Trim Upper Bumper; Each
Reproduction of the original style rinner quarter trim upper bumper designed for use with 1992-2002 Camaro, Corvett, and Firebird models. Each bumper is manufactured to correct factory specifications replicating the original...
1982-04 GM; Hood Adjustment Rubber Bumper & Bolt; 1" Diameter; Each; Various Models
Replace your original rubber hood adjuster stoppers with a correctly configured reproduction hood adjustment bumper. This part replace the adjuster bolt and the rubber bumper for a complete bolt-on replacement of the...
1991-96 Buick, Chevrolet; 1993-96 Cadillac; 1991-92 Oldsmobile; Hood Side Bumper; Each
OER reproduction of the original hood side anti-rattle bumper designed for use on 1991-96 GM models. Manufactured from quality molded rubber, each bumper is an exact replica of the original. Sold individually. Buick models...
1987-2016 GM; Rear Trunk Lid Access Hole Plug; Each; Various Models
Reproduction trunk lid drain hole plug for 1987-2016 GM vehicles including 1991-96 Impala and Caprice models. Manufactured from molded rubber as original, these install on the underside of the trunk lid. Measures 9/165"...
1991-96 Camaro, Impala, Caprice, Firebird; Trunk Lid Rubber Bumper, Each
Reproduction of the original trunk lid rubber stopper designed for use on 1991-96 GM vehicles including Camaro, Firebird, Impala, and Caprice models. Each bumper is manufactured in the correct configuration to fit exactly...
1955-1981 GM; Firewall Pad Fastener; Each
This reproduction firewall pad fastener is designed to hold the firewall insulation pad in place on various 1955-81 General Motors models. Each fastener is manufactured from EPDM rubber replicating the original configuration...
1951-75 Convertible Power Top Motor Mounting Grommet - Each
Reproduction of the original rubber mounting / insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a...
1968-96 Impala, Chevelle, Corvette; Hood Rear Panel Bumper, Each, Various Models
Reproduction of the original rear hood panel bumper designed for use on various 1968-96 GM models. Exact reproduction of the original rear hood bumper used to replace the worn out or missing original. Manufactured to exact...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
1970-87 Buick, Chevrolet, Olds, Pontiac; Upper Control Arm Bumper; Various Models; Each
Reproduction control arm bumper for Buick, Chevrolet, Oldsmobile, and Pontiac models. This upper control arm bumper is designed to replicate the factory original and is essential for proper suspension travel and ride control....
1982-93 Glove Box Door/Ashtray Bumper
Reproduction of the anti-rattle rubber bumper for the glove box door on 1982-85 Impala and 1982-93 Caprice models and for the ash tray on 1990 Caprice models. Measures 5mm in height and fits a 3mm hole. 2 required per...