Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head
Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...
Flat Washer; 1/2" USS; Zinc Plated
1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...
1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon
Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...
Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate
OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...
1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each
Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...
OER reproduction of the original front windshield glass for use with various Buick, Cadillac, Oldsmobile E-Body 2 & 4 door coupe, and convertible models as listed below. This windshield is manufactured with tempered laminate...
1981-87 Buick Regal, T-Type, GNX, Grand National; Front Bumper; Chrome
Reproduction of the original front bumper designed for use on 1981-87 Buick Regal. T Type and Grand National models equipped with a chrome bumper. Each bumper is manufactured to factory specifications featuring all factory...
1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Vinyl Storage Bag
Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot vinyl storage bag. The storage bag will help protect your vehicles top boot while being stored in...
1978-88 Regal, Cutlass, Grand Prix, G Body; T Top Repair Panels; 8-Piece Set; Stainless Steel
Reproduction inner t-top repair panel set for 1978-88 Buick, Chevrolet, Oldsmobile, and Pontiac G-Body models, produced in stainless steel for longevity. Stamped to factory specifications, for a proper fit. Comes in an...
1959-72 Buick; Chevrolet; Oldsmobile; Pontiac; Trunk Lock Latch Assembly; Manual; Various GM Models
This OER® reproduction of the original manual trunk lid latch assembly. This correct reproduction installs in the trunk area and is connected to the trunk lock cylinder by the handle shaft. Allows the trunk lid to lock...
U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each
Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...
Replace the worn or rusted out rear floating bow or rear tacking rail with this quality reproduction. This 1-piece tack strip, also referred to as a trimstick mounts to the frame just behind the quarter glass and secures the...
3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each
Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...
OER reproduction windshield glass for various Buick, Chevrolet, Pontiac, and Oldsmobile B & C-Body models. This windshield is manufactured with tempered laminate safety glass that meets the standard for protection against...
OER reproduction windshield glass for various GM B & C-Body models. This windshield is manufactured with tempered laminate safety glass that meets the standard for protection against road debris. Windshield is supplied in a...
Reproduction of the original back window glass for various 1981-89 GM wagon models with 9-hole rear tailgate glass with defroster. Manufactured with the proper shape, curvature, and pattern in OEM equivalent tempered glass...
Reproduction of the original back window glass for various 1977-90 GM wagon models with 9-hole rear tailgate glass without defroster. Manufactured with the proper shape, curvature, and pattern in OEM equivalent tempered glass...
Wiper Blade Insert; Replacement; 16" Anco Style; Each
OER reproduction Anco-style windshield wiper blade insert for various classic American vehicle models from the 1960's and up. These 16" wiper blades are manufactured from quality molded rubber as original. Refill is...
1981-87 Buick Regal, Grand National; Front Bumper Impact Strip; Black Without Accent Paint
Reproduction front bumper impact strip for 1981-87 Buick Regal models. Manufactured to factory specifications for proper fitment and appearance. The impact strip is inserted into the front bumper. Note: This bumper impact...
Brand New Reproduction wiper motor built using the industry's most advanced engineering technology. Core shortages and low availability have made our brand new replacement wiper motors the high quality, low cost alternative...