Product#: 3415

Bumper Bolt with Conical Keps Hex Nut; Polished Stainless Steel Capped Head; 3/4" Diameter; 3/8-16" x 1"; Zinc Plated

Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...


Product#: 2710

Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head

Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...


Product#: 8610

Flat Washer; 1/2" USS; Zinc Plated

1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...


Product#: 13757

1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon

Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...


Product#: 9785616

1955-82 Spare Tire Hold Down Nut; 5/16"-18 Thread; 3.88" Wide; Zinc Finish

OER® reproduction wing nut for many GM models. This spare tire hold down nut is used in conjunction with the spare tire hold down rod. Manufactured in stamped steel and features correct threads and wing nut design....


Product#: 10362

Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate

OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...


Product#: 3899508

1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each

Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...


Product#: K106

1968-69 Camaro, Firebird, 1968-79 Nova, X-body; Door Hinge Rebuild Kit

Reproduction of the original components necessary to rebuild the door hinges on various GM models. Each door hinge set includes hinge pins, retaining clips, bushings, tension springs, roller detent studs and hardware for...


Product#: 344330

1968-79 Camaro, Chevelle, Impala, Nova, Ventura; Rear License Plate Bracket; with Hinge; EDP Coated

Reproduction rear license plate bracket for various 1968-79 GM models including 1969-77 Camaro, 1968-71 Impala, 1968-72 Chevelle, 1968-79 Nova, Omega, Apollo, Ventura, and more. Manufactured in stamped steel to factory...


Product#: 356515

1975-79 Nov, Ventura, Skylatk, Omega, 1975-81 Firebird; Body Mount Bushing; Lower; # 2 Position

Replacing the original bushings with rubber reproductions is a sure fire way of maintaining originality and mounting the subframe exactly the way the factory intended. Replaces OE # 356515. {fitment}


Product#: K51020

1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Vinyl Storage Bag

Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot vinyl storage bag. The storage bag will help protect your vehicles top boot while being stored in...


Product#: 3063212

1969 Camaro, Firebird, 1968-79 Nova; Lower Door Hinge; Drivers Side; Various Models

Reproduction of the original door hinge assembly designed for use on the various applications listed below. Each door hinge is manufactured in cast steel replicating the original in quality and design. Features four bolt...


Product#: 11503957

U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...


Product#: NR674T

1975-79 Nova/X-Body; 4-Door Sedan; Windshield Glass; With Antenna; Tinted and Shaded

OER glass is the ultimate in first class restorations. Windshields are tempered laminate safety glass designed for protection against road debris. Features tinted laminated glass with blue/green shaded band at the top, with...


Product#: 3063211

1969 Camaro, Firebird, 1968-79 Nova; Lower Door Hinge; Passenger Side; Various Models

Reproduction of the original door hinge assembly designed for use on the various applications listed below. Each door hinge is manufactured in cast steel replicating the original in quality and design. Features four bolt...


Product#: 9817407

1969 Camaro, Firebird, 1968-79 Nova; Upper Door Hinge; Drivers Side; Various Models

OER® reproduction of the upper door hinge designed for use on various GM models. Door hinges are manufactured in quality heavy duty stamped cast iron steel ensuring long lasting dependability. Will fit and install same as...


Product#: A1017

3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each

Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...


Product#: NR675T

1975-79 Nova/X-Body; 4-Door Sedan; Windshield Glass; Without Antenna; Tinted

OER glass is the ultimate in first class restorations. Windshields are tempered laminate safety glass designed for protection against road debris. Features tinted laminated glass with blue/green shaded band at the top,...


Product#: A40140

1968-87 Buick, Chevrolet, GMC, Oldsmobile, Pontiac; Windshield Wiper Motor; Non-Concealed Wipers; Brand New

Brand New Reproduction wiper motor built using the industry's most advanced engineering technology. Core shortages and low availability have made our brand new replacement wiper motors the high quality, low cost alternative...


Product#: 3926830

1968-79 Hood Hinge Assembly ; RH ; Various Models

Reproduction of the original hood hinge assembly designed for use on various 1968-79 GM models. Each hood hinge is manufactured from heavy duty stamped steel assuring a quality replacement. We recommend replacing the hood...