Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1970-74 Challenger, Barracuda, Cuda;Molded Door Seal End Cap, Pair
Factory-style replacement door seal end caps designed for use on 1970-74 Dodge and Plymouth E-Body hardtop and convertible models. This end cap is mounted to the door edge with screws and caps off the edge of the door...
1971-74 Barracuda, Cuda, Challenger; Roof Rail Weatherstrip ; 2 Door; Coupe; Pair; OER
Reproduction of the original style roof rail weatherstrip that installs along the roof rail section from the pillar to the rear window along the roof line. Each weatherstrip is manufactured with quality E.D.P.M rubber...
1960-76 Dodge/Plymouth; Rubber Body and Trunk Plug; 1-7/8"; Each
Reproduction of the original style body and trunk rubber plug designed for use on most 1960-76 Dodge or Plymouth models where a 1-7/8" hole plug is required. Manufactured in quality rubber material for an original appearance,...
1970-74 Mopar Door Jamb Seal Screw Set ; 16 Piece ; E-Body
Reproduction of the original door jamb and door end seal screws for 1970-74 Mopar B-Body vehicles. These phillips head screws are black-oxide coated and designed to accurately replace the screws in the door jamb seals and the...
1970-74 Dodge/Plymouth E-Body; Hood To Cowl Seal
Reproduction of the original hood to cowl seal weatherstrip for use on 1970-74 Mopar E-body models. This weatherstrip will help keep water and dirt out of the engine bay by sealing the area between the cowl panel and hood....