Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 Buick, Chevrolet, Pontiac, Oldsmobile; Door Lock Gasket; Each; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
1964-79 Camaro, Chevelle, Firebird, Nova, X-Body; Outer Door Handle Gasket Set; Various Models
Reproduction of the original outer door handle gasket set designed to properly seal the exterior door handles on various classic vehicle applications. Each set includes precision die-cut gaskets manufactured to factory...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1970-81 Camaro, Firebird, 1973-74 Nova; Outer Door Bullet Mirror Gasket; RH or LH; Each
Correct reproduction of the original outer door bullet mirror gasket designed for use on various GM models as listed. This gasket separates the mirror base from the outer door metal. For use with bullet style mirrors in the...
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1968-76 Remote Outer Door Mirror Gasket ; Various Models
Reproduction of the original outer door remote mirror mounting gasket for use with the various applications listed. Each gasket is manufactured to replicate the original is fitment and design. Can be used with the original...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
Reproduction license plate / fuel door stoppers for the rear license bracket. These are OE type reproductions manufactured to exact OE specifications. Sold in pairs. 9/16" diameter, 13/16" tall. GM Note: REV. 5-80 (cut 1/4"...
1967-74 Upper Clutch Push Rod Boot - Various Models
This OER® reproduction of the original upper push rod molded rubber boot is manufactured using correct E.D.P.M. rubber compound stock that is superior to the original. Molded in steel insert distributes mounting screw...
Correct reproduction of the original power window harness rubber boots which is used to house the power window wiring harness as it passes between the door jamb and door area. This rubber boot is manufactured in durable...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
Reproduction of the original outer door handle and door lock gasket set designed to properly seal and protect the exterior door handle and lock areas on various vehicle models. Each gasket is precision die-cut to factory...