Rubber Floor Pan Plug; 1-1/4" Diameter. Fits 1" Hole; Each
Reproduction rubber floor pan plug measures 1-1/4" diameter and fits a 1" hole. Sold individually, use as required.
1961-81 Buick, Chevy, Pontiac, Oldsmobile; Trunk Lid Rubber Bumper On Lid; Each; Various Models
Correct reproduction of the original trunk lid rubber bumper for use with various 1961-81 Buick, Chevy, Pontiac, and Oldsmobile models. Manufactured in EPDM rubber to factory specifications. Used to eliminate the trunk lid...
1959-79 Buick, Chevy, Pontiac, Oldsmobile; Seat Back Bumper; Oval Style; Each; Various Models
Reproduction of the original oval style seat back bumper designed for use on various 1959-79 GM vehicles. Each bumper is manufactured in hard rubber including a steel core for added strength. The bumper is installed where the...
1970-77 Chevrolet El Camino, Monte Carlo, 1970-73 Chevelle; Hood Stop Stud; Pair
New hood stop studs for 1970-73 Chevrolet Chevelle and 1970-77 Monte Carlo that mount on cowl firewall. 2 are used per car. These lock the hood in back. Sold as pair only. These have the special head with "C". {specs}...
1958-77 Buick, Chevy, Olds, Pontiac; Hood Adjust Bumper and Screw Set; Various Models
Reproduction hood adjustment bumpers for various 1958-77 GM models including 1967-69 Camaro and Firebird models. These 7/8" OD reproduction stoppers and screws are manufactured to original specifications to replace the worn...
1955-1981 GM; Firewall Pad Fastener; Each
This reproduction firewall pad fastener is designed to hold the firewall insulation pad in place on various 1955-81 General Motors models. Each fastener is manufactured from EPDM rubber replicating the original configuration...
1951-75 Convertible Power Top Motor Mounting Grommet - Each
Reproduction of the original rubber mounting / insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a...
Reproduction license plate / fuel door stoppers for the rear license bracket. These are OE type reproductions manufactured to exact OE specifications. Sold in pairs. 9/16" diameter, 13/16" tall. GM Note: REV. 5-80 (cut 1/4"...