Universal Frame Mount Manual Brake Pedal Bracket Assembly; GM Booster Style; Under Floor Mount
Universal frame mount brake pedal assembly for GM style brake booster with 4 bolt 3-3/8? center. For automatic transmission equipped, left hand drive hot rod and truck models. Great for under the floor, frame mount...
1973-84 Chevy, GMA; Frame Side Clutch Pivot Ball; 7/8" Ball; 3/8"-16
Accurately machined frame pivot ball stud fits all original and reproduction big and small block clutch bellcranks. Heat treated for hardness as original replicating the original in design and appearance. Overall length is...
Brake and Clutch Pedal Bushing Set; Nylon; For 5/8" Diameter Shaft; 5/8" Deep; 4-Piece Set
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...
Reproduction clutch bell crank (Z-bar) pivot stud nylon seat and retainer set for 1958-88 Chevrolet, Buick, Oldsmobile, and Pontiac models equipped with a manual transmission. These plastic inserts allow the clutch bell crank...
1962-83 GM Clutch Fork Boot; 3-1/2" x 2-5/8"
OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...
1955-81 Retainer Clip; Trans Control Rod, Clutch Push Rod, Throttle Rod Swivel
OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...