1964-72 Buick, Chevrolet, Oldsmobile, Pontiac; Fuel Tank Vent Tube Grommet; Each
Replacement vent tube grommet for 1964-72 GM models. Manufactured to factory dimensions, this molded rubber grommet fits in the trunk pan and features two holes for the fuel vent tube to pass through.
Reproduction roof rail weatherstrip channel set for 1970-72 Chevrolet Chevelle, Buick Skylark, and Gran Sport (GS) 2-door hardtop models. Manufactured to factory specifications, this 6-piece stainless steel set installs along...
Reproduction roof rail weatherstrip channel connectors for 1968-72 Chevrolet Chevelle, Pontiac GTO, Tempest, LeMans, Buick Skylark, Oldsmobile 442, Cutlass, F85, and 1970-72 Chevrolet Monte Carlo 2-door hardtop models....
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1966-72 Chevrolet; Standard Door Mirror Gasket
Quality reproduction outer door mirror gasket for various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors. Installs between the mirror base and...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber; Various Models
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...