1963-72 Buick, Chevrolet, Oldsmobile, Pontiac; Hood Hinge Spring; For Steel Hoods
Reproduction hood hinge spring for various GM models including Chevelle, Camaro, Impala, Firebird and other various GM models. Each spring is designed and manufactured to exact factory specifications for the models listed...
1958-77 GM; Hood Adjuster Bolt and Nut Set ; 5/16"-18 x 1-3/8"; Various Models
Reproduction of the original hood stop bolt and nut set designed for use on various 1958-77 GM models. This bolt and nut set will keep the hood adjusted to the proper height. These 5/16"-18 x 1-3/8" bolts include the correct...
1965-72 Hood Hinge Spring; Chevy II, Nova, Impala
The hood hinge spring is an important part of the hood hinge assembly. Replace the old worn out hood springs on your GM vehicle with this quality reproduction. Each spring is manufactured to original specifications and...
1970-72 Chevrolet Chevelle, El Camino, Monte Carlo; Hood Release Handle
Reproduction of the original hood latch release rod handle designed for use with 1970-72 Chevelle, El Camino and Monte Carlo models. Each rod is manufactured in quality stamped steel replicating the original in configuration,...
Reproduction hood pin rubber gasket found on models with hood pins. Each gasket is die-cut to proper dimension. Will also fit a wide variety of aftermarket hood pins. Sold individually. Use as required. Check measurements...
1958-77 Buick, Chevy, Olds, Pontiac; Hood Adjust Bumper and Screw Set; Various Models
Reproduction hood adjustment bumpers for various 1958-77 GM models including 1967-69 Camaro and Firebird models. These 7/8" OD reproduction stoppers and screws are manufactured to original specifications to replace the worn...
1965-1970 GM; Hood Insulation Fastener Set; 20 Piece Set; Various Models
Reproduction of the original hood insulation fasteners designed for various 1965-69 GM models. Manufactured in injection molded ABS plastic to replace OE part number # 3909199. These are an exact copy of the OE retainer for...
1967-69 Camaro, Firebird; Plastic Clip Set; Radiator Support To Hood Seal; 9 Piece Set
Reproduction of the radiator support to hood seal clip set designed for 1967-69 Camaro and Firebird models with air conditioning. Each clip is injection molded to original specifications. Clips are designed to hold the hood...
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
1968-96 Impala, Chevelle, Corvette; Hood Rear Panel Bumper, Each, Various Models
Reproduction of the original rear hood panel bumper designed for use on various 1968-96 GM models. Exact reproduction of the original rear hood bumper used to replace the worn out or missing original. Manufactured to exact...