1970 Chevrolet Camaro Parts - Clutches & Parts

Correct reproduction brake and clutch pedal pad trim plate for various 1967-81 GM models with manual transmission. Each steel pedal trim plate is designed to replicate the original in fit, appearance and design. {specs} ...

This is The plastic clutch Z bar insert set that allow the bar to pivot on the clutch ball These are present on most all GM cars from 1962-81 with a manual transmission. This four piece set which includes 3 nylon bushings and...

OER® reproduction of the original clutch fork return spring which attaches from the clutch fork to the frame rail on models with manual transmissions. This reproduction spring replicates the original in every detail. Will...

Reproduction brake or clutch pedal pad for a variety of GM models equipped with manual transmissions and drum brakes. Manufactured in quality EPDM rubber replicating the original horizontal ribbed design. This pedal pad can...

OER® reproduction of the lower clutch push rod designed for use on various GM models. Includes right angle shell portion correctly swaged and internally threaded to match the lower clutch push rod adjuster for 6 cylinder...

OER® reproduction of the original frame side clutch bellcrank pivot ball bracket designed for use on 1970-81 Camaro and Firebird models with manual transmissions. This steel bracket attaches to the vehicles frame....

Reproduction of the original style clutch housing and flywheel cover plate designed for use on a variety of 1964-81 Chevrolet models as listed. Manufactured in stamped steel to original specifications that replicate the...

OER® reproduction clutch fork bellhousing boot for GM models from 1955 to 1983. This reproduction boot will replace the old or worn out original exactly. Manufactured in quality EPDM rubber compound for durability and...

OER® reproduction upper clutch push rod boot for various 1970-81 Buick, Chevrolet, Oldsmobile and Pontiac models. Each clutch rod boot is manufactured in quality EPDM rubber matching the original boot cosmetically in...

OER® reproduction clip for a variety of different parts on 1955-81 GM vehicles. This clip was used to attach the throttle valve control rod, throttle lever rod swivel, and the upper and lower clutch push rods. Use as...

Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8"...

Reproduction of the original pedal pads designed for 1969-71 Camaro and 1970-71 Firebird models equipped with 3" brake and clutch pedal. Each pad is manufactured to original factory specs! 8 piece set includes the 3" brake...

This complete kit is designed to replace pedal pads and trim plates on 1970-71 models with floor mounted gas pedal , drum brakes and a manual transmission. For models with the 3" clutch pedal. To ensure proper fit, measure...

This complete kit is designed to replace pedal pads and trim plates on 1970-71 models with floor mounted gas pedal , drum brakes and a manual transmission. For models with the 3" clutch pedal. To ensure proper fit, measure...

Correct reproduction of the original return spring extension rod designed for use on various GM models as listed. This rod is used in conjuntion with the clutch fork return spring. Together they connect the clutch fork to the...