1965-2002 GM; Door Lock Striker Washer; 3.50MM Thick; Each
Correct reproduction of the original threaded striker washer for use on 1965-2002 Buick, Chevrolet, Pontiac, and Oldsmobile models as listed. The door lock striker washer is installed on the door jamb for either the right or...
Door Lock Striker Bolt Washer Shim ; 1.25MM Thick ; Each
Reproduction of the original door striker bolt shim manufactured in die-stamped steel and finished in clear zinc coating. Used to correctly position the door striker bolt for proper alignment with the door latch assembly. Use...
Spring Steel Rod Clip, for Carburetor, Door, Tailgate; LH Driver Side
OER® Authorized reproduction of the original style carburetor rod to accelerator rod clip for various models. Each clip is manufactured in stamped steel and heat treated for strength and durability. For use on the various...
1968-70 Dodge, Plymouth B-Body; Door Latch and Lock Clip Set
Reproduction of the various components required to help keep your door latch operating smoothly. Replacing the door latch and lock clips will help keep your doors operating properly just the way the factory intended. Includes...
1968-70 Mopar Striker Plate Shim 1.50MM ; B-Body
Correctly stamped reproduction of the original 1968-70 striker shim plate designed for use on B-Body models. Manufactured in die-stamped steel with zinc plating for corrosion resistance. Designed to shim the door striker...
Door Lock Striker Bolt Washer Shim ; 2.00MM Thick ; Each
Reproduction of the original door striker bolt shim manufactured in die-stamped steel and finished in clear zinc coating. Used to correctly position the door striker bolt for proper alignment with the door latch assembly. Use...
1968-70 Mopar Striker Plate Shim .60MM ; B-Body
Correctly stamped reproduction of the original 1968-70 striker shim plate designed for use on B-Body models. Manufactured in die-stamped steel with zinc plating for corrosion resistance. Designed to shim the door striker...
1966-74 Mopar A / B / E-Body Lower Door Hinge Spring
When you are rebuilding your door hinges don?t stop at pins and bushings, make sure you replace those worn out springs at the same time. Replace the worn out hinge spring with this reproduction designed to fit and function...
Replacement oval stainless steel Phillips head door latch screws used on various GM vehicles from 1965-1981. 1/4-20 x 5/8". 6 piece set. Correct hardware can make any installation job easier. Replace your missing or...
Door Lock Striker Bolt Shim - 4.00MM Thick ; Each
Reproduction of the original door striker bolt shim manufactured in die-stamped steel and finished in clear zinc coating. Used to correctly position the door striker bolt for proper alignment with the door latch assembly. Use...
5/16-18 X 3/4; Phillips Head Screws; 4 Piece Set
Reproduction of the original zinc plated screws designed to install the door striker plates on various models. One set will install striker plates for both RH and LH doors. Includes 4 screws.
1968-70 Dodge, Plymouth; Door Striker Plates; with Screws; Various Models
Reproduction door striker plates originally installed on 1968-70 Dodge and Plymouth B-Body models. Each plate is manufactured in stamped steel and zinc coated for long lasting dependability. Set includes 2 door striker plates...
1959-1993 GM; Door Inside Locking Rod Clip; Various Models; Each
This replacement lock rod clip is designed to hold the door lock knob rod assembly to the lower rod assembly which pivots up and down when the door lock knob is raised or lowered. This is an essential part that is required in...