1964-72 Buick, Chevrolet, Oldsmobile, Pontiac; Fuel Tank Vent Tube Grommet; Each
Replacement vent tube grommet for 1964-72 GM models. Manufactured to factory dimensions, this molded rubber grommet fits in the trunk pan and features two holes for the fuel vent tube to pass through.
Reproduction roof rail weatherstrip channel set for 1966-67 Chevrolet Chevelle, Pontiac GTO, Tempest, LeMans, Buick Skylark, Gran Sport, and Oldsmobile 442, Cutlass, and F85 2-door hardtop models. Manufactured to factory...
1967-68 Camaro RS; Molded Rubber Tail Lamp & Park Lamp Lens Gasket Set; OE Style; Light Gray
Reproduction exterior lens gaskets to replace the old or worn out originals on 1967-68 Camaro Rally Sport models. This replacement gasket set includes both rear tail light lens to housing gaskets, the rear license lamp...
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 Buick, Chevrolet, Pontiac, Oldsmobile; Door Lock Gasket; Each; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...
1964-79 Camaro, Chevelle, Firebird, Nova, X-Body; Outer Door Handle Gasket Set; Various Models
Reproduction of the original outer door handle gasket set designed to properly seal the exterior door handles on various classic vehicle applications. Each set includes precision die-cut gaskets manufactured to factory...
1966-72 GM; Outer Mirror Mounting Set ; LH or RH ; Gasket, Bracket, Screws
Reproduction of the original style components required to replace and mount the outer door mirror on the door. Contains all the necessary hardware to install a standard outer door mirror onto either the drivers or passenger...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1967-69 Camaro, 1968-72 Chevy II, Nova; Hood Louver Gasket; Each
Reproduction of the original hood louver gaskets that seal the hood louvers to the hood. These gaskets are manufactured to precisely replace the old or worn originals. Prevents water and other elements from seeping past the...
1966-72 Chevrolet; Standard Door Mirror Gasket
Quality reproduction outer door mirror gasket for various GM models. Manufactured to factory specifications in quality injection molded ABS, will fit original GM or reproduction mirrors. Installs between the mirror base and...
1967-72 Chevy, GMC C/K Pickup Truck; Door Seal Weatherstrip Set; Pair
Reproduction of the original style door seal weatherstrip for use with 1967-72 Chevrolet & GMC pickup truck models. This weatherstripping is manufactured in quality EPDM rubber offering an authentic fitment that will seal the...
1967 Camaro, Firebird; Vent Frame Weatherstrip, RH and LH; Pair
Correct molded reproduction of the original vent frame weatherstripping designed for use on 1967 Camaro and Firebird models. Designed and manufactured to exact factory specifications, each weatherstrip will replace the...
Reproduction of the original style door frame weatherstripping designed for use on various GM full size models including 1967-68 Buick, Chevy, Cadillac, Pontiac,Oldsmobile Full Size passenger cars for 2 door hardtop or 2 door...
1967 Camaro, Firebird; Convertible Pillar Post Weatherstrip; Molded; Pair
Quality reproduction of the original pillar post weatherstrip designed for use on 1967 Camaro and Firebird convertible models. Each weatherstrip is manufactured from durable E.P.D.M weatherstrip for authenticity and fit. This...
1967-1972 Chevy, GMC Truck, Blazer, Jimmy, Suburban; Outer Door Handle & Lock Gasket Set; RH & LH
OER® Authorized reproduction exterior door handle and lock cylinder gasket set designed for use with 1967-72 Chevrolet and GMC Truck, Blazer, Jimmy, and Suburban models. This 10-piece kit provides all the necessary...
1966-67 Chevelle, El Camino; Front Fender Splash Apron Set; RH & LH; Pair
Replace your worn or missing splash aprons with these factory-style OER reproductions and restore proper protection to your engine bay. Each premium splash apron set is manufactured to exact OE specifications, ensuring a...
1967-81 Camaro, Firebird; Trunk Weatherstrip Seal; OER
Reproduction trunk weatherstrip for 1967-81 Camaro and Firebird models. Each rubber weatherstrip measures 13-1/2 feet in length, and is manufactured with correctly configured extruded rubber. The weatherstrip is extruded to...
1967-69 Camaro, Firebird; Quarter Window Vertical Weatherstrip; with OE Style Steel Insert; Pair
Superb quality reproduction of the original side quarter window vertical weatherstrip designed for use on all 1967-69 Camaro and Firebird models. Manufactured in quality EPDM rubber to exact factory dimensions. These...
1967-68 Camaro; Upper Fuel Tank Neck Rubber Sleeve
Reproduction upper fuel tank neck rubber sleeve for 1967-68 Chevrolet Camaro models. This reproduction rubber sleeve surrounds the gas tank neck and protects against gasoline, water or other elements causing possible damage...
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
1967-68 Camaro, Firebird; Front Fender Inner Splash Apron Set
Reproduction inner splash apron set designed for 1967-68 Camaro models. These splash shields are essential for maintaining the proper seal between the fender skirt and engine bay, helping to keep the engine compartment...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1967-72 Chevrolet/GMC Truck Outer Door Mirror Gasket; LH/RH
OER® reproduction of the original outer side mirror gasket for use on 1967-72 models. Includes molded lip just like original! Replace the original worn out gasket with this excellent reproduction. Fits original or...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber; Various Models
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
1967-68 Impala, Wildcat, Delta 88; Roof Rail Weatherstrip Seal, 2-Door Fastback; Pair
Reproduction of the original roof rail weatherstrip designed for use on 1967-68 Impala 2 door Fastback, Wildcat, Le Sabre, and various GM models as listed below. This quality reproduction weatherstripping is manufactured in...
Correct reproduction of the original roof rail weatherstrips designed for use on 1967-68 Impala and Full Size GM 2 door hardtop models. Eliminate water or other elements from entering the passenger area by replacing these...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1967 Impala; Tail Lamp to Body Gasket; RH & LH; Pair
Reproduction of the original die-cut rear tail lamp gaskets designed to replace the old or worn out originals on 1967 Impala models. These gaskets seal the tail light to the body. Sold in pairs. NOTE: Made in the USA!
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
1967-69 Camaro, Firebird; Interior Door Jamb Rubber Seals; Pair
Correct OER® reproduction of the 1967-69 style original molded rubber seals that attach to the door jamb section directly below the rear side window vertical weatherstrip. These reproduction door jamb seals are...
1967-74 Upper Clutch Push Rod Boot - Various Models
This OER® reproduction of the original upper push rod molded rubber boot is manufactured using correct E.D.P.M. rubber compound stock that is superior to the original. Molded in steel insert distributes mounting screw...
1962-78 Nova, Camaro, Firebird, Impala, Truck; Speedometer Cable Firewall Grommet; w/Steel Insert
Quality reproduction of the original speedometer cable firewall grommet designed for use on various 1962-73 Chevy II Nova, Camaro, Impala, Bel Air, Biscayne, Caprice, Firebird, and 1973-78 Chevrolet, GMC truck models as...
1954-1981 GM; Hood Adjustor Rubber Bumper & Stud; Various GM Cars & Trucks
Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...
1967-72 Chevrolet & GMC Fleetside Pickup; Tailgate Rubber Bumpers; 4 Piece Set
Reproduction rubber tailgate bumpers for 1967-72 GM Fleetside pickup truck models. Replacing the tailgate rubber stoppers will help ensure alignment of the tailgate and provide sound dampening when closing the gate. Each...
1965-67 Impala, Bel Air, Biscayne, Caprice; Hood To Cowl Seal Weatherstrip
High quality reproduction of the original weatherstrip seal that attaches to the front cowl panel and seals the area between the hood and windshield. This reproduction is manufactured to exact configuration allowing the seal...
1967-72 Chevy, GMC Pickup, Blazer, Suburban; Truck Hood To Cowl Seal, Various Models
OER® reproduction of the original hood to cowl seal for all 1967-72 Chevrolet and GMC trucks, Suburbans, 1969-72 Blazer and 1970-72 Jimmy models. Manufactured in the correct configuration for an authentic replacement of...
1967-68 Camaro RS; Park Light & Back Up Light Paint Seal Gasket Supplement; 4 Piece Set
Supplimental paint seal set designed for use on 1967-68 Camaro Rally Sport models. Set includes the 1967 front park lamp housing to body gaskets and 1967-68 back-up lamp housing to body gaskets. Each gasket replicates the...
Correct reproduction of the original power window harness rubber boots which is used to house the power window wiring harness as it passes between the door jamb and door area. This rubber boot is manufactured in durable...
OER® reproduction of the original console seal cover originally installed on 1967 Camaro, 1967 Firebird or 1968-72 Chevy II/Nova models with a factory 3 or 4-speed manual transmission. Each seal is manufactured to exact...
1967-69 Camaro, Firebird; Door Jamb Welt Retainer Clips; Pair
Reproduction of the original spring steel door jamb windlace retaining clips for 1968-69 Camaro, Firebird models. These clips are a direct replacement for the commonly damaged or missing originals. Includes drivers and...
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
1958-72 Buick, Chevy, Olds, Pontiac; Trunk Lid Rubber Stopper; Each; Various Models
Correct OER® reproduction of the original trunk lid rubber bumpers designed for use with various 1958-72 GM models. These rubber bumpers are engineered to replicate the factory originals in design, fit, and function. Each...
1964-91 Chevy, GMC Pickup, Blazer, Jimmy, Suburban; Door Rubber Bumper Set, 4 Piece Set
OER® reproduction of the original door rubber bumpers designed for use on 1964-1986 C/K and 1987-91 R/V model Chevrolet and GMC pickup trucks. Each rubber stopper is designed to exact factory specifications for a perfect...
1966-70 Evaporator Case Drain Hose Rubber Seal - with AC
OER® reproduction of original evaporator case drain hose that attaches to the bottom portion of the evaporator core outlet case on various 1966-70 GM models originally equipped with air conditioning. Each drain hose is...
1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER
Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...
1967 Chevy Camaro; Exterior Paint Seal Gasket Set; Standard Models; 11 Piece Set
A complete set of reproduction gaskets designed for use on 1967 Camaro models. Each gasket is a replication of the original and replaces the outer body gaskets for the door handles, rear tail lights, outer mirror gasket,...
1961-79 GM; Transmission Control Cable Grommet; OER
OER® reproduction of the original GM transmission control cable grommet for all 1961-79 GM models. Designed to factory specifications in the correct configuration for a perfect fit and manufactured in rubber as original....
1967-68 Chevrolet; Inner Fender Air Conditioning Hose Grommet; Various Models
Reproduction of the original AC hose grommet designed for use on 1967-68 GM models. Located on the RH front fender well, this hose grommet insulates the AC hoses from the condensor to the engine compartment. Manufactured in...
Reproduction of the original outer door handle and door lock gasket set designed to properly seal and protect the exterior door handle and lock areas on various vehicle models. Each gasket is precision die-cut to factory...