1966 Impala Tail Lamp To Body Gasket Set ; 14 Piece
Reproduction of the original tail lamp lens gaskets designed for use on 1966 Impala models. Each gasket is die-cut to exact specifications ensuring the correct and proper fitment between the lens and housing. Includes a...
Staple For Inner Fender Splash Apron, 1/2 inch
Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.
1955-90 GM; Door Lock Gasket; Various Models
Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...
1965-79 GM; Door Handle Gasket Set; Outer; Various Models
This reproduction gasket set includes a complete set of door handle gaskets used to install the outer door handles on the various models listed below. Each set includes correct die-cut gaskets for both RH and LH outer door...
1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each
Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...
1962-81 Trunk Lock Cylinder Gasket ; Die-Cut Replacement
Reproduction die-cut trunk lock cylinder gasket designed to seal the trunk lock cylinder to the body. This gasket is designed for use on the listings below. Each gasket will fit and function as original. This is a non-molded...
1958-75 Clutch Bellcrank Felt Seals ; Pair
OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...
1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber
Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...
1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each
This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....
1966 Impala Tail Lamp Lens to Housing Gaskets ; Pair
Reproduction of the original die-cut rear tail lamp gaskets designed to replace the old or worn out originals on 1966 Impala models. These gaskets seal the tail light lens to the tail lamp housing assembly. Includes 6...
1966-1979 Camaro, Impala, Nova; Rubber Side Hood Bumper ; Each
Reproduction of the original style side hood rubber bumper designed for use various GM models. Over time, the rubber stoppers on your hood can wear out or deteriorate. These reproduction stoppers will help keep your hood...
1965-67 GM Full Size; Hood To Cowl Seal
High quality reproduction of the original weatherstrip seal that attaches to the front cowl panel and seals the area between the hood and windshield. This reproduction is manufactured to exact configuration allowing the seal...
1965-66 Fullsize Quarter Window Vertical Weatherstrips, 4 Door Hardtop, Pair
Quality reproduction of the original weatherstripping designed for use on 1965-66 Impala and Full Size GM models. Each strip is manufactured with OEM type rubber material for authenticity and fit. Installs vertically on the...
1965-92 Outer Door Rubber Bumper; Various Models
Reproduction of the original rubber stopper designed for use on the upper door section of the various GM models listed below. Each rubber stopper is manufactured to replicate the original in fitment and appearance. This...
1958-72 GM; Trunk Lid Rubber Stopper; Each; Buick, Chevy, Olds, Pontiac; Various Models
Correct OER® reproduction of the original trunk lid rubber bumpers designed for use with various 1960-72 GM models. Manufactured to factory specifications including correct stud to adjust for height concerns. Eliminates...
1966-70 Evaporator Case Drain Hose Rubber Seal - with AC
OER® reproduction of original evaporator case drain hose that attaches to the bottom portion of the evaporator core outlet case on various 1966-70 GM models originally equipped with air conditioning. Each drain hose is...
1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER
Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...
1964-79 GM Door Lock and Door Handle Gasket Set - Various Models - 6 Piece Set
This reproduction door handle and door lock gasket set includes a complete set of door handle gaskets and door lock gaskets used to install the outer door handles and door locks on the various models listed below. Each set...