1963-64 Impala, Bel Air, Biscayne; Rubber Stopper Kit; 16 piece set
Reproduction of the original style rubber stoppers designed for use on 1963-64 Chevrolet Impala, Bel Air, and Biscayne models. Achieve a clean tailored appearance of your Chevrolet's body panels by replacing the old or worn...
Rubber Floor Pan Plug; 1-1/4" Diameter. Fits 1" Hole; Each
Reproduction rubber floor pan plug measures 1-1/4" diameter and fits a 1" hole. Sold individually, use as required.
1961-83 GM; Seat Back Rubber Bumper Stopper; Various Uses & Models; Each
Correct replacement of the rubber bumper for use on various GM models. This rubber stopper will help insure that your seat/hood is aligned properly. Sold individually. Use as required per vehicle. 1-3/16" long, diameter of...
1942-77 GM; Hood Adjustment Rubber Bumpers; Round; Pair; Various Models
Reproduction hood adjustment bumpers for various 1942-77 GM models. These 7/8" OD reproduction stoppers are manufactured in quality rubber and designed to replace the worn out, deteriorated, or lost originals. Allows for a...
1958-77 Buick, Chevy, Olds, Pontiac; Hood Adjust Bumper and Screw Set; Various Models
Reproduction hood adjustment bumpers for various 1958-77 GM models including 1967-69 Camaro and Firebird models. These 7/8" OD reproduction stoppers and screws are manufactured to original specifications to replace the worn...
1955-1981 GM; Firewall Pad Fastener; Each
This reproduction firewall pad fastener is designed to hold the firewall insulation pad in place on various 1955-81 General Motors models. Each fastener is manufactured from EPDM rubber replicating the original configuration...
1962-66 Chevrolet; Door Rubber Bumper Set; 4 Piece Set; Various Models
Replacing the rubber door stoppers will help keep your doors aligned correctly while adding a factory fresh appearance to the vehicle. Each rubber bumper is designed and manufactured to exact OE specs. Manufactured in quality...
1962-81 GM; Glove Box Door Arm Rubber Bumper
OER® reproduction of the original glove box door arm rubber bumper designed for use with various 1962-81 GM models. This rubber bumper is manufactured in EPDM rubber to the original factory configuration. Was installed on...
1951-75 Convertible Power Top Motor Mounting Grommet - Each
Reproduction of the original rubber mounting / insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a...
1958-72 Buick, Chevy, Olds, Pontiac; Trunk Lid Rubber Stopper; Each; Various Models
Correct OER® reproduction of the original trunk lid rubber bumpers designed for use with various 1958-72 GM models. These rubber bumpers are engineered to replicate the factory originals in design, fit, and function. Each...