Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...
Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head
Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...
Flat Washer; 1/2" USS; Zinc Plated
1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...
1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon
Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...
1962-1977 GM; Windshield Washer Jar Bracket; Various Models
OER® replacement of the original windshield washer jat bracket designed for use on various 1962-77 GM models as listed. This bracket is manufactured in stamped steel and features an EDP coating for rust resistance. This...
1962-72 Chevrolet/Pontiac; OE Style Firewall Pad Fastener; Plastic; 7/16" X 1.50"; Various Models
Correct reproduction plastic firewall pad fastener for various GM models including 1967-69 Camaro, 1967-69 Firebird, 1962-72 Nova and 1962-69 Impala models. These fasteners are required to allow the firewall pad to attach...
Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate
OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...
1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each
Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...
1962-64 Impala, Bel Air, Biscayne 2 & 4-Door Sedan; Rear Window Glass; Custom Gray Tinted
Reproduction back window glass for various 1962-64 Buick, Chevy, Oldsmobile, and Pontiac Full Size 2 and 4 door sedan models except bubble top. Each rear window glass is manufactured in tempered glass to factory...
1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Vinyl Storage Bag
Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot vinyl storage bag. The storage bag will help protect your vehicles top boot while being stored in...
1958-80 TRICO RF-15 Style Wiper Blade Refill; 15" Length; Reproduction; Various Models
OER® reproduction of the original Trico RF-15 wiper blade insert/refill for 15" TRICO wiper blades. This period-correct TRICO RF-15 style insert is made with a stainless steel vertebra and a precision wiping edge produced...
1959-72 Buick; Chevrolet; Oldsmobile; Pontiac; Trunk Lock Latch Assembly; Manual; Various GM Models
This OER® reproduction of the original manual trunk lid latch assembly. This correct reproduction installs in the trunk area and is connected to the trunk lock cylinder by the handle shaft. Allows the trunk lid to lock...
Reproduction of the original front windshield glass for use with 1961-62 Buick, Chevrolet, Pontiac, and Oldsmobile Full Size 2 & 4 door, sedan, hardtop, and station wagon models as listed. This windshield is manufactured with...
U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each
Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...
1961-62, 1965-68 Impala, Bel Air, Biscayne, Caprice; Front Outer Door Handle Set; 2 or 4 Door
Quality reproduction outer door handle set for 1961-62 and 1965-68 Impala and Full Size models. Each door handle set is manufactured in zinc die-cast zinc and includes a high quality triple chrome plating offering a factory...
3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each
Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...
Windshield Wiper Blades; Aero Style; 15"; for 1/4" (7mm) Bayonet Style Arms; Pair; Various Models
High quality reproduction of the stainless steel "Aero" Anti Wind-Lift Wiper Blades designed to fit 7mm wide bayonet style wiper arms. Popularized in the 1960's and 70's to combat wind lift at high speeds, these 15 inch wiper...
1962-64 Impala, Full Size Hardtop, Sedan; Trunk Lid Hinges; LH & RH; EDP Finish
Reproduction trunk lid hinges for 1962-64 Chevrolet Impala, Bel Air, and Biscayne hardtop and sedan models. These hinges are manufactured in quality stamped steel to factory specifications and feature correct torque rod...
1947-79 GM; Various Models; Chrome Drop Mount Peep Mirror; LH Or RH; 4"
OER® Authorized reproduction drop head mirror for 1941-79 GM model cars and trucks. Early style drop head mirror mount to top edge of door frame. Features a chrome arm with a 4 inch mirror head. Fits sedan and truck...
Correctly reproduced glass windshield washer bottle that was common in various 1955-72 General Motors vehicles. Each bottle is manufactured in the correct factory configuration that replaces the old or missing original...