Product#: STAPLES

Staple For Inner Fender Splash Apron, 1/2 inch

Correct staple to install fender skirt splash aprons for various models. 1/2" wide, 1/2" deep.


Product#: K940

1955-90 GM; Door Lock Gasket; Various Models

Reproduction of the original door lock gasket designed for use on various GM models including the listings below. After repainting your doors, or whenever replacing door locks, be sure to install new lock cylinder gaskets to...


Product#: 152767

1958-71 Buick, Chevy, Pontiac, Olds; Door Weatherstrip Attaching Hole Sealing Plug, 27/64" Diameter; Each

Reproduction weatherstrip clip receiver seal for 1958-71 GM models. These small plugs are inserted into the door and provide a mounting point for the door frame weatherstrip clips to insert into. Sold individually. 26...


Product#: 1667195

1955-1976 GM; Rubber Floor Pan Plug; Fits 1-1/2" Hole; Each

Reproduction of the original round rubber floor pan plug installed on various 1955-76 General Motors vehicles. Found in various locations on the floor pan, these plugs are manufactured to factory specifications in quality...


Product#: CX1170

1960-66 Chevrolet,/GMC Truck, Suburban; Outer Mirror Gasket; LH

OER® Authorized reproduction outer door mirror gasket for 1960-66 Chevrolet and GMC truck models. Includes molded lip just like original GM gasket. Replace the original worn out gasket with this excellent reproduction....


Product#: W9901

1960-66 Chevy, GMC Pickup, Suburban; Door Frame Weatherstrip Seals, Press-On; Pair

New Tooling for 2024! Reproduction of the original "press-on" style door weatherstrip seal which eliminates the need to use weatherstrip glue for installation. Weatherstrip mounts on the pinchweld of the body and fits the RH...


Product#: CX1169

1960-66 Chevrolet,/GMC Truck, Suburban; Outer Mirror Gasket; RH

OER® Authorized reproduction outer door mirror gasket for 1960-66 Chevrolet and GMC truck models. Includes molded lip just like original GM gasket. Replace the original worn out gasket with this excellent reproduction....


Product#: 5953464

1962-64 Chevy II, Nova; Tail Lens Gasket; Pair

Reproduction of the original tail lamp lens gaskets for use with 1962-64 Chevy II, Nova models. This is the gasket that installs between the tail lamp housing and the lenses. Includes RH & LH tail lamp gaskets manufactured in...


Product#: 3743360

1958-75 Clutch Bellcrank Felt Seals ; Pair

OER® reproduction of the original die-cut felt seals that slips over the bellcrank pivot studs and seals against the end of the bellcrank tube to prevent dirt and water damage. Manufactured to correct dimensions. Sold in...


Product#: K2016

1961-64 Impala, 1961-62 Bel Air; U Shape Door Jamb Rubber Seals, with Screws; Pair

Correct reproduction of the of the original U-shaped rubber door jamb rubber seals designed for use on 1961-64 GM Impala 2 door hardtop models. Each U-shape seal is manufactured to original specifications including a steel...


Product#: 4471426

1965-72 Chevrolet, Oldsmobile; Trunk Lock Cylinder Gasket; Molded Rubber

Reproduction of the original trunk lock cylinder gasket designed for use on various GM models. This gasket is used to seal the trunk lock cylinder to the body. Manufactured in quality EPDM molded rubber that replicates the...


Product#: CX1300

1952-66 Chevrolet/GMC Pickup Outer Door Handle Gasket Set

Reproduction of the original door handle pads for 1952-66 Chevrolet and GMC trucks. This set is for a two handles to both sides. One set is required per vehicle. Note: For a half set that includes gaskets for a single door,...


Product#: 4861854

1962-64 Chevy II, Nova; Tail Lamp Housing to Body Gaskets; Molded Rubber; Pair

Reproduction molded rubber gasket set for tail lamp housing on 1962-64 Chevy II/Nova hardtop or sedan. Manufactured with OEM equivalent materials, each set will seal the lamp assembly between the body and the housing to...


Product#: 4156548

1955-79 Outer Door Handle Push Button O-Ring Gasket ; Each

This door handle O-ring is one of the most overlooked replacement parts on any vehicle. The O-ring inserts onto the outer door handle push button and eliminates rattling and wear between the handle and the push button....


Product#: 3792008

1962-78 Nova, Camaro, Firebird, Impala, Truck; Speedometer Cable Firewall Grommet; w/Steel Insert

Quality reproduction of the original speedometer cable firewall grommet designed for use on various 1962-73 Chevy II Nova, Camaro, Impala, Bel Air, Biscayne, Caprice, Firebird, and 1973-78 Chevrolet, GMC truck models as...


Product#: 340999

1954-1981 GM; Hood Adjustor Rubber Bumper & Stud; Various GM Cars & Trucks

Reproduction 5/16-18 x 1-1/2" hood bumper. Includes correctly threaded stud with a 1" diameter x 1/2" tall round rubber top. Helps keep the hood aligned when installed. Can be adjusted higher or lower. 2 hood adjust bumpers...


Product#: N180

1962-65 Chevy II, Nova; Quarter Panel Door Jamb Seals, 2 Door Hardtop & Coupe; Pair

Correct reproduction of the original door jamb U shape rubber seals that install on 1962-65 Chevy II and Nova 2 door hardtop and coupe models. Each U shape rubber seal is manufactured to the correct configuration and hole...


Product#: 4721222

1958-72 Buick, Chevy, Olds, Pontiac; Trunk Lid Rubber Stopper; Each; Various Models

Correct OER® reproduction of the original trunk lid rubber bumpers designed for use with various 1958-72 GM models. Manufactured to factory specifications including correct stud to adjust for height concerns. Eliminates...


Product#: BC1028

1955-76 Chevrolet Bel Air, 150, 210, Impala, Caprice; Fender Skirt Rubber Seal ; 120" Long; OER

Reproduction fender or quarter panel skirt rubber seal for various 1955-76 Chevrolet models. Manufactured to correct dimensions from quality EDPM rubber that replicates the original in fitment and appearance. Measures 120"...


Product#: K4060

1962-65 Chevy II, Nova; Rear Bumper To Body Seal; Made in the USA!

Excellent reproduction of the original rear body to bumper weatherstripping designed for use on 1965-65 Chevy II and Nova models. The bumper to body seal strip is designed to seal and fill the area where the rear bumper meets...